HOSE AS 2370983 - Caterpillar

Illustration 1 g01647353
Only use this chart in order to lift and tie down a machine that is disassembled as the original shipment from the factory.
The machine shipping weight of the 795F AC will depend on the configuration and the options.
A machine may shift if improper procedures or equipment are used for lifting and tying down for transport. Ensure that proper equipment and procedures are used for lifting and tying machines down for transport. If a machine shifts it could cause personal injury or death.
Improper lifting or tie-downs can allow the machine to shift. This can cause damage to the machine.
This machine is not intended to be lifted after assembly. This machine is not intended to be tied down after assembly.
For instructions on the assembly of this machine, refer to Special Instruction, REHS4417, "795F AC Drive Off-Highway Truck Assembly Procedure".
Weight and instructions are listed herein. This information is applicable to units that are manufactured by Caterpillar.
For lifting objects, use properly rated cables and properly rated slings. Position the crane for a level machine lift.
Spreader bar widths should be sufficient for preventing contact with the machine.
Use the two rear holes and two front holes that are provided for tie-downs.
Place suitable blocking under the machine and in front of the machine in order to stabilize the machine in the tie-down position. Install the tie-downs at the designated locations.
Check the appropriate laws that govern the weight of the load. Check the appropriate laws that govern the width of the load and the length of the load.
Consult your Caterpillar dealer for shipping instructions for your machine.Lift and Tie Down Messages
Lifting Point - This message is located on points that are used to attach lifting devices.
Tie Down Point - This message is located on points that are used to attach tie-downs.