HOSE 2410566 - Caterpillar

Required Parts
Illustration 1 g00814541
Table 1
Required Parts    
Item    Part Number    Description    Qty    
1     5P-6129     Tube (
0.61 m (2 ft))     -    
2     5P-4961     Hose Clamp     1    
3     7T-9793     Valve     1    
4     6B-8692     Boss (1)     1    
5     9M-7961     Fitting     1    
( 1 ) This boss is required when you rework the 163-0379 Support (enclosure).
Illustration 2 g00814587
(A) Location for drilled hole (B) 20 mm (0.79 inch)Installation Procedure
Remove the enclosure cover.
Drill a 1/2 inch hole at location (A) on the 163-0379 Support (enclosure).
Use a bolt and a washer to position the 6B-8692 Boss in place. This is at location (A) on the bottom of the enclosure. Make sure that the boss does not protrude past the edge of the enclosure's bottom.
Weld the boss to the enclosure. (Two 1/2 inch welds that are spread apart by 180 degrees should be sufficient.) Remove the bolt and the washers that were used to hold the boss in place.
Install 9M-7961 Fitting into the boss.
Install the 7T-9793 Valve in the 610 mm (24 inch) piece of the 5P-6129 Tube. Moisten the valve before installation. Then insert the valve at least 1 inch into the tube. Make sure that you install the valve so that the pointed end is facing out of the tube.
Install the opposite end of the tube on the 9M-7961 Fitting and fasten the tube in place by using the 5P-4961 Hose Clamp. Check the valve in the opposite end of the tube. Make sure that the pointed end of the valve is pointed downward.
Reinstall the cover. Note: When you install the cover, slide up the cover on the clearance holes for the mounting bolts as far as possible in order to get the best possible seal across the top.