HOSE AS 2472731 - Caterpillar

30. Remove the bolt, retainer (37), yoke (38) and the O-ring seal from the shaft.31. Remove distributor (39) from carrier (stator) (36). Remove the lip-type seal from the distributor. 32. Remove shaft (19) from carrier (stator) (36). 33. Remove the seal rings from carriers (40) and (42).34. If necessary, remove carrier (40), bearing (41) and carrier (42) from shaft (19) with a press.Assemble Torque Converter
Some of the pictures in the following procedure are typical examples. Although the pictures may look slightly different than the parts, the procedure is the same. 1. If the carriers and bearing were removed, install carrier (3), bearing (2) and carrier (1) on shaft (4) as shown.2. Install the ring in the groove of carrier (3).3. Install new rings in the grooves of carrier (1). 4. Put shaft (4) in position in carrier (stator) (5). 5. Install the lip-type seal in distributor (6) with the lip down as shown.6. Install two 3/8 " - 16 NC guide bolts in carrier (5). Align the passages in distributor (6) and carrier (5). Put the distributor in position on the carrier, and install the bolts that hold it. Tighten the bolts to a torque of 54 3 N m (40 2 lb ft)7. Put clean torque converter oil on seal in distributor (6).8. Put the yoke, O-ring seal and retainer in position on the shaft, and install the bolts that holds. Tighten the bolts to a torque of 251 12 N m (185 9 lb ft). 9. Heat bearing (11) to a maximum temperature of 135° C (275° F). Put bearing (11) in position on carrier (5), and install the retaining ring that holds it.10. Install seals (9) and (10) on carrier (5).11. Put race (7) in position on carrier (5). Put two washers (8) that hold race (7) in position as shown, and install the bolts that hold them. Tighten the bolts to a torque of 30 3 N m (22 2 lb ft) 12. Put gear (13) in position in housing (12), and install the bolts that hold it. Tighten the bolts to a torque of 54 3 N m (40 2 lb ft)13. Turn the housing over, and install the sleeve in the bore of the housing. Lower the temperature of the sleeve if necessary. 14. Put impeller (14) in position in the housing as shown, and install the bolts that hold it from the outside of the housing. Tighten the bolts to a torque of 80 4 N m (60 3 lb ft)15. Put hub assembly (15) in position on the hub and the counterbore of impeller (14). Install the bolts and hold the hub assembly, and tighten them to a torque of 54 3 N m (40 2 lb ft)16. Put bearing (16) in position on the hub assembly as shown.
Be careful not to damage the seals when installing the housing.
17. Put the housing with the impeller, hub assembly and