HOSE AS 2476387 - Caterpillar

? Disassembly and Assembly ? 950GWheel Loader and 962G Wheel Loader Machine SystemsRENR4323 ? Disassembly and Assembly ? 950GSeries II Wheel Loader and 962G Series II Wheel Loader Machine SystemsSENR3130 ? Torque SpecificationsSEBF8493 ? Contamination Control Guideline? Procedure for Kidney Looping Small and Medium Wheel Loader, Landfilland Soil Compactor, and Integrated Tool Carrier Hydraulic OilSEBU6250 ? Caterpillar Machine Fluids Recommendations
Install Implement Pump. Refer to Disassembly andAssembly, "Vane Pump (Implement)-Install".
Install Steering Pump. Refer to Disassembly andAssembly, "Piston Pump (Steering) ? Install".
Install Pilot and Brake Pump. Refer to Disassemblyand Assembly, "Vane Pump (Pilot and Braking ? Install".
Pre-fill the Implement, Steering, Pilot and Brakepumps with recommended hydraulic oil before installing cab.
Install the cab. Refer to Disassembly and Assembly,"Cab ? Install". Tighten the four cab mounting bolts to a torque of 850+/- 100 N.m (629 +/- 74 lb. ft.).
Replace hydraulic oil filter with a 102-2828 highefficiency filter. The high efficiency filter should be replacedafter a maximum of 250 hours. Then a standard filter may be used.
Before starting engine, fill hydraulic tank withrecommended hydraulic oil. Always use clean oil when you add oil to thesystem. Clean oil must be at an ISO level of at least 16/13.
Crank the engine at least five times without startingthe engine. Wait for at least five seconds between cranks in order to allowthe oil to flow smoothly through the system.
Check the oil level in the hydraulic tank. Ifnecessary, refill the tank.
Start the engine at low idle. Allow the engineto run for several seconds. Stop the engine.
Check the oil level in the hydraulic tank. Ifnecessary, refill the tank.
Start the engine and maintain low idle. Maintainhydraulic oil level until it reaches the full mark on hydraulic oil levelsite gauge.
Cycle, at low idle, the tilt cylinder a minimumof three times. Do not allow the circuit to go into relief.
Check the oil level in the hydraulic tank. Ifnecessary, refill the tank.
Cycle, at low idle, the lift cylinders a minimumof three times. Do not allow the circuit to go into relief.
Check the oil level in the hydraulic tank. Ifnecessary, refill the tank.
Cycle, at low idle with frame lock installed,the steering circuit to a full right and full left turn.
Check hydraulic oil level and add oil if necessary.Remove frame lock link, cycle steering to full right and full left.
Check hydraulic oil level and add oil if necessary.
Take a Scheduled Oil Sample (SOS). Refer to ContaminationControl Guidelines, SEBF8758. If cleanliness is not at the acceptable ISOlevel of 18/15, perform a kidney looping procedure. Use 2047392/">204-7392 FilterCart for kidney looping in accordance with Contamination Control Guidelines,SEBF8493.
Filtration time for 950/962 is calculatedas: Hydraulic Oil Capacity (Gallons) x 2 = Minimum Minutes of Filtrationis needed an example would be if a system contains 60 gallons of oil thenthe filtration time will be 120 minutes or 2 hours minimum.966G and 972G Series I and II Implement Pump ServiceLetter ProcedureNote: All safety related information mustbe read and practiced when performing this procedure.This service procedure is to be performed whenan Implement Pump failure occurs.If a failure of the implement pump has