AVSPARE.COM
parts catalog

HOSE AS 2500512 - Caterpillar



2500512 HOSE AS Caterpillar parts HOSE
Rating:
16
Alternative (cross code) number:
CA2500512
250-0512
2500512
Caterpillar 2500512 HOSE AS

Buy HOSE AS 2500512 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:


At operating temperature, the hydraulic tank is hot and under pressure.Hot oil and components can cause personal injury. Do not allow hot oil or components to contact skin.Remove the filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand. Remove the filler cap slowly to relieve pressure.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Operate the machine in order to warm the oil.Park the machine on level ground. Lower the bulldozer blade and the ripper to the ground and apply slight downward pressure. Engage the parking brake and stop the engine.
Illustration 1 g03855687
Remove the hydraulic tank filler cap slowly in order to relieve any pressure.
Wash the filler strainer and the filler cap in a clean nonflammable solvent.
Illustration 2 g03282737
Remove the oil drain plug cover. Remove the oil drain plug. The oil drain plug is located under the right fender.
Attach a hose to a 126-7914 Swivel. Install the swivel and the hose into the drain plug opening. A pipe nipple 10 cm (4 inch) and a hose can also be used. Use a 25.4 mm (1 inch) pipe with 1-11 1/2 NPTF threads. Do not tighten the pipe.
Rotate the swivel clockwise in order to open the internal drain valve. Allow the oil to drain into a suitable container.
Remove the swivel. The valve for the hydraulic tank will close.
Clean the drain plug and install the drain plug. Tighten the drain plug to a torque of 68 7 N m (50 5 lb ft). Install the oil drain plug cover.
Change the hydraulic system filter. See Operation and Maintenance Manual, "Hydraulic System Oil Filter - Replace".
Install the filler strainer.
Fill the hydraulic oil tank. See Operation and Maintenance Manual, "Refill Capacities" in order to determine the amount of hydraulic oil that is needed to fill the hydraulic oil tank.
Inspect the filler cap gasket. Replace the gasket if damage or wear is evident.
Install the filler cap.
Start the engine. Run the engine for a few minutes.
Illustration 3 g03282776
Maintain the oil level to the "FULL" mark in the sight gauge. Check with the attachments on the ground and with cold oil. Add oil, if necessary.
Stop the engine.


Parts hose Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.