HOSE AS 2500555 - Caterpillar

23 Fasten hose (20) to bracket (12) with clips (32).24 Use strap (33) to fasten hose (27) to hose (20) at the location shown. Fasten hoses (27), (30) and (31) to hose (20) with strap (34) at the location shown.25 Use spacer (35) and clips (36) to fasten hoses (27), (30) and (31) to the top of the bevel gear case. Use clip (37) to fasten hose (31) to the valve.26 Install guard (38). On tractors without ROPS cab or canopy, install the three doors. On tractors with ROPS cab or canopy, install the cover or doors.27 Connect the ripper lines to the control valve as shown in Special Instruction Form SMHS6767. On tractors without ROPS cab, install the seat.Installation Of Control Linkage On Tractors Without ROPS Cab
A Ripper Control Linkage
1 Install bracket (1) on angle (2). Put lever (3) in position in bracket (1), and install shaft (4) and dowel (5).2 Install the boot, nut and rod end (6) on rod (7). Install rod (7) on lever (3) and the valve stem of the pilot valve with nut (8), pin (9), and the cotter pin. 3 Install spring (10) and seal (11) on lever (3).4 Adjust rod end (6) so lever (3) is in a vertical position. Push boot (12) down into position over the valve stem.5 Install the dozer control linkage as shown on page 29 or 30.B Non-Tilting Dozer Control Linkage
1 Install bracket (1) on angle (2). Put shaft (3) in position on bracket (1), and install levers (4) and (5), two keys, bolts and nuts. Put nuts (6) and rod ends (7) on rod (8). Install the rod ends on levers (5) and (9) with bolts (10) and nuts (11) and (12).2 Install spring (13), dome (14) and guide (15) on lever (4). 3 Install cover (16) and arm rest cushion (17). Install cover (18) and the screws. Install handle (19) on the lever.4 On tractors without a ripper, install covers (20) and (21). On tractors with a ripper, install cover (20) and the handle.5 Adjust rod ends (7) to get handle (19) in the position shown. 6 Remove the bolt and the lug from floorplate (22). Install plate (23). Install bracket (24) on plate (23). Install the floorplates.7 Install the film (decal) for the dozer at location (A). On tractors with a ripper, install the film (decal) at location (B).C Tilt Dozer Control Linkage
1 Install bracket (1) on angle (2). Put shaft (3) in position in bracket (1), and install lever (4), key, bolt and nut. Put lever (5) on shaft (3), and install shaft (6) and the dowel.2 Install nuts (7) and rod ends (8) on rod (9). Install rod ends (8) on levers (4) and (10) with bolts (11) and nuts (12) and (13). Install the boot, nut (14) and rod end (15) on rod (16). Put rod end (15) in position on lever (5), and install nut (17). Put rod (16) in position on valve stem (18) of the