2500715 HOSE AS Caterpillar parts 307C, 307D, 308C, 308D HOSE
Rating:
Alternative (cross code) number:
CA2500715
250-0715
2500715
CA2500715
250-0715
2500715
Buy HOSE AS 2500715 Caterpillar genuine, new aftermarket tractor parts with delivery
MINI HYD EXCAVATOR,
Number on catalog scheme:
8
For full view, you need register
Information:
1. Remove the frame lock pin and put it in stored position. 2. Remove the wheel lean lock pin and store it in the machine tool box. 3. Open the fuel tank drain and drain the moisture and sediment. Close the drain. Drain the moisture and sediment from the air reservoir. Check the engine oil level. Maintain the oil level in the SAFE STARTING range on the ENGINE STOPPED side of the dipstick. Check the hydraulic tank oil level. Maintain the oil level to the FULL mark in the sight gauge. Check the radiator coolant level. Maintain the coolant level above the indicator plate in the bottom of the radiator fill pipe. Check the transmission and differential oil level. Maintain the oil level to the FULL mark on the dipstick. Observe the air cleaner indicator. Service the air cleaner when the indicator shows red.Test the Supplemental Steering (If Equipped)
A dead cell in the machine's batteries will result in a loss of supplemental steering capability.
Hold the switch in the MANUAL position only long enough to test the supplemental steering. Do not exceed five minutes. Allow the pump and solenoid to cool.
To Test
The supplemental steering will not function unless the disconnect switch is in the ON position. 1. Turn the disconnect switch to ON. 2. The supplemental steering fault indicator (1) should blink and the fault light should flash until the engine is started. The supplemental steering motor indicator should go ON for three seconds. While the motor indicator (2) is ON, the effort required to steer the machine should be nearly the same as the effort required when using the machine's primary steering system.3. Start the engine. The supplemental steering fault indicator and fault light as well as the motor indicator should go OFF.4. With the engine running, move and hold the supplemental steering switch (3) on the control console to MANUAL. The motor indicator (2) should go ON. The machine should steer normally. The supplemental steering indicator fault light (1) should stay off.5. With the engine at LOW IDLE, the transmission modulator pedal and the brake pedal depressed and the transmission control in the highest gear, release the transmission modulator pedal to stall the engine.The supplemental steering indicator fault light (1) and the motor indicator (2) should go ON. The machine should steer normally. Pull the accelerator pedal up to the engine stopped position.The motor indicator (2) should go OFF, the supplemental steering indicator (1) and fault light should stay ON.6. Turn the start key switch to OFF to turn off the supplemental steering system.Seat Belt
Always check the condition of the seat belt and mounting hardware before operating the machine.Replace the seat belt at least once every three years, regardless of appearance. A date label, to determine the age of the belt, is sewn onto each belt.
Inspect for worn or frayed webbing. Check for worn or damaged buckle or anticreep slide, on each half of the belt. Replace the belt, buckle or slides if they are worn or
A dead cell in the machine's batteries will result in a loss of supplemental steering capability.
Hold the switch in the MANUAL position only long enough to test the supplemental steering. Do not exceed five minutes. Allow the pump and solenoid to cool.
To Test
The supplemental steering will not function unless the disconnect switch is in the ON position. 1. Turn the disconnect switch to ON. 2. The supplemental steering fault indicator (1) should blink and the fault light should flash until the engine is started. The supplemental steering motor indicator should go ON for three seconds. While the motor indicator (2) is ON, the effort required to steer the machine should be nearly the same as the effort required when using the machine's primary steering system.3. Start the engine. The supplemental steering fault indicator and fault light as well as the motor indicator should go OFF.4. With the engine running, move and hold the supplemental steering switch (3) on the control console to MANUAL. The motor indicator (2) should go ON. The machine should steer normally. The supplemental steering indicator fault light (1) should stay off.5. With the engine at LOW IDLE, the transmission modulator pedal and the brake pedal depressed and the transmission control in the highest gear, release the transmission modulator pedal to stall the engine.The supplemental steering indicator fault light (1) and the motor indicator (2) should go ON. The machine should steer normally. Pull the accelerator pedal up to the engine stopped position.The motor indicator (2) should go OFF, the supplemental steering indicator (1) and fault light should stay ON.6. Turn the start key switch to OFF to turn off the supplemental steering system.Seat Belt
Always check the condition of the seat belt and mounting hardware before operating the machine.Replace the seat belt at least once every three years, regardless of appearance. A date label, to determine the age of the belt, is sewn onto each belt.
Inspect for worn or frayed webbing. Check for worn or damaged buckle or anticreep slide, on each half of the belt. Replace the belt, buckle or slides if they are worn or
Caterpillar parts catalog:
Parts hose Caterpillar catalog:
120H, 120H ES, 120H NA, 120M 2, 135H, 135H NA, 236D, 242D, 246D, 257D, 259D, 262D, 272D, 272D XHP, 277D, 279D, 2864C, 287D, 289D, 299D, 299D XHP, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304, 304C CR...
1090, 1190, 1190T, 1290T, 1390, 2290, 2390, 2391, 2491, 2590, 303, 303.5, 303.5C, 303.5D, 303.5E, 303C CR, 303E CR, 304, 304.5, 304C CR, 304D CR, 304E, 305, 305.5, 305.5D, 305.5E, 305C CR, 305D CR, 30...
307C, 308D, 312C, 312C L, 314C, 316E L, 318C, 318E L, 319C, 320B, 320C, 320C L, 320D FM, 320D L, 320D LN, 321C, 321D LCR, 322B, 322B L, 322C, 323D L, 323D LN, 323D SA, 324D, 324D FM, 324D FM LL, 324D ...
307C, 311C, 312C, 312D, 312D L, 312D2, 312D2 GC, 312D2 L, 312E, 312E L, 313D, 313D2, 313D2 LGP, 315D L, 318C, 318D L, 318D2 L, 319C, 319D, 319D L, 320 L, 320B, 320C, 320D, 320D FM, 320D GC, 320D L, 32...
307C, 308D, 311F LRR, 312D, 314D CR, 314D LCR, 314E CR, 314E LCR, 315D L, 316E L, 318C, 318D2 L, 318E L, 319D, 319D L, 319D LN, 320 L, 320B, 320B L, 320C, 320C FM, 320C L, 320D, 320D FM, 320D FM RR, 3...
307C, 308C, 315C, 315D L, 319D L, 320B, 320C, 320C FM, 320C L, 320D, 320D L, 320D LRR, 320D RR, 320E LRR, 321D LCR, 322, 322 FM L, 322B, 322B L, 322C, 322C FM, 323D L, 324D FM, 325, 325 L, 325 LN, 325...
307C, 308C, 311D LRR, 311F LRR, 312C, 312C L, 314D CR, 314D LCR, 315D L, 316E L, 318C, 318D L, 318D2 L, 318E L, 319C, 319D, 319D L, 319D LN, 320B, 320C, 320C FM, 320C L, 320D FM, 320D LRR, 320D RR, 32...
308C, 312C, 312C L, 312D, 312D L, 314D LCR, 314E CR, 314E LCR, 315C, 315D L, 318C, 318D L, 318D2 L, 319C, 319D, 319D L, 319D LN, 320C, 320C FM, 320D, 320D FM, 320D GC, 320D L, 320D LRR, 320D RR, 320D2...
308C, 311C, 311D LRR, 311F LRR, 314C, 314D CR, 314D LCR, 314E CR, 314E LCR, 315C, 318C, 319C, 320C, 320D, 320E L, 320E LN, 321C, 321D LCR, 322C, 322C FM, 323E L, 325 L, 325B, 325C, 325C FM, 325D L, 33...
1795298
HOSE AS
307C, 308C, 311D LRR, 314D LCR
307C, 308C, 311D LRR, 314D LCR
2502073
HOSE AS
307C, 308C
307C, 308C
2109966
HOSE AS
307C, 308C, 311C, 315D L, 316E L, 318D2 L, 318E L, 320D, 320D L, 320D LRR, 320D RR, 320D2, 320D2 L, 320E LN, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D L, 324D LN, 324E L, 324E LN, 325D, 32...
307C, 308C, 311C, 315D L, 316E L, 318D2 L, 318E L, 320D, 320D L, 320D LRR, 320D RR, 320D2, 320D2 L, 320E LN, 323D L, 323D LN, 323D SA, 323D2 L, 323E L, 324D, 324D L, 324D LN, 324E L, 324E LN, 325D, 32...
1778659
HOSE AS
307C, 308C, 311C, 314C, 314D CR, 314D LCR, 321C, 324E LN
307C, 308C, 311C, 314C, 314D CR, 314D LCR, 321C, 324E LN
2558929
HOSE AS
307C, 308C, 966H, 972H, CVP16
307C, 308C, 966H, 972H, CVP16
3337812
HOSE AS
307C
307C
1653438
HOSE AS
307C
307C
3523584
HOSE AS
307C, M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH
307C, M313D, M315D, M316D, M318D, M318D MH, M322D, M322D MH
2377505
HOSE AS
307C, PIN GRAB
307C, PIN GRAB
1863623
HOSE AS
307C, PIN GRAB
307C, PIN GRAB
1863622
HOSE AS
307C, PIN GRAB
307C, PIN GRAB
1863620
HOSE AS
307C, PIN GRAB
307C, PIN GRAB