HOSE AS 2505851 - Caterpillar

Illustration 25 g03320845
Assemble 231-2875 Support As (1) to Plate (35). Use two 8T-4195 Bolts (4) and two 8T-4121 Hard Washers (3). Assemble 232-1540 Seal (10) to 231-2875 Support As (1) .
Illustration 26 g03320847
Insert 353-3433 Shaft As (2) into 231-2875 Support As (1) .
Illustration 27 g03320851
Assemble two 8T-4133 Nuts (14) to 366-5460 Rod (24). Assemble 8T-6431 Rod End (22) to one end of the rod assembly. Assemble one 8T-4773 Ball Joint (22) to the other end of the rod assembly.
Illustration 28 g03320854
Assemble one 8T-4121 Hard Washer (3) to 8T-4773 Ball Joint (20). Assemble one 8M-3175 Hard Washer (18) on to 8T-4186 Bolt (17). Assemble the 8T-6431 Rod End (19) to 8T-4186 Bolt (17). Secure rod end (19) with one 6V-7744 Locknut (23). Assemble 8T-4773 Ball Joint (20) to 353-3433 Shaft As (2). Secure with one 6V-7744 Locknut (23) .
Illustration 29 g03312518
(M) 145 2 mm (5.71 0.08 inch) (N) 97 2 mm (3.82 0.08 inch)
Make sure that the setting for the rod is the same dimension that is shown in Illustration 29.
Illustration 30 g03321003
Secure 231-2876 Pedal As (5) to 353-3433 Shaft As (2) with 6V-8335 Self-Locking Bolt (7) and 8T-4121 Hard Washer (3) .Note: Make sure that 353-3433 Shaft As (2) can move freely through 231-2875 Support As (1) and 231-2876 Pedal As (5). Also make sure that the side to side movement of the pedal is minimized. Assemble 231-2876 Pedal As (5) so that there is 0.5 mm (0.020 inch) to 1.0 mm (0.039 inch) of side play in 231-2876 Pedal As (5) .
Refer to Disassembly and Assembly, UENR2321, "416F Backhoe Loaders Machine Systems", "Bank Valve (Backhoe) - Install".
Illustration 31 g03321034
Install console (30) with two screws (32) .
Illustration 32 g03321036
Install console (30) onto the machine with four bolts (28) and four washers (29). Place decal (31) onto the machine.
Illustration 33 g03316782
Place 133-8916 Film (8) and 198-0098 Film (9) onto console (30) .