HOSE AS 2512010 - Caterpillar

Illustration 22 g03806567
Remove O-ring seals (39) from pilot valve (38).
Illustration 23 g03807496
Remove fittings (40) and the O-ring seals. Remove plug (41) and the O-ring seal.
Illustration 24 g03807499
Remove tilt control valve bank (42).
Repeat Steps 3 through Step 11 for tilt control valve bank (42).
Illustration 25 g03807498
Remove cover (43).
Illustration 26 g03807502
Use Tooling (A) to remove relief valve (44).
Illustration 27 g03807503
Use Tooling (B) to measure from the top of relief valve (44) to the top of plug assembly (45). Record this measurement for assembly purposes.
Illustration 28 g03807506
Improper assembly of parts that are spring loaded can cause bodily injury.To prevent possible injury, follow the established assembly procedure and wear protective equipment.
Remove retaining ring (46) and O-ring seal (47). Remove plug assembly (45). Remove spring (48) and valve (49). Remove O-ring seal (50) and (52). Remove Backup ring (51).
Illustration 29 g03807509
Remove nut (53) and solenoid (54).
Illustration 30 g03807510
Remove cartridge (55).
Illustration 31 g03807515
Remove orifice plug (56).
Illustration 32 g03807517
Remove O-ring seals (57). Remove backup ring (58).
Illustration 33 g06297202
Remove plug (59), the O-ring seal, and the orifice plug (not shown). Remove plug (59A) and the O-ring seal. Remove relief valve (60).
Illustration 34 g03807521
Remove O-ring seals (61). Remove backup rings (62).
Illustration 35 g03807523
Mark the orientation of the remaining fittings (63) for assembly purposes.
Remove studs (64). Remove the remaining fittings (63) and the O-ring seals from manifold (65).