HOSE 2537175 - Caterpillar

Air Induction
One of the single most important aspects of compressor preventive maintenance is the induction of clean air. The type and interval of maintenance required will vary depending upon the air induction system used.The intervals listed under the headings below pertain to typical highway and street operation. More frequent maintenance will be required for operation in dusty or dirty environments.
Fig. 9 Polyurethane Sponge StrainerPolyurethane Sponge Strainer
Every month, 150 operating hours or 5,000 miles, whichever occurs first, remove and wash all of the parts. The strainer element should be cleaned or replaced. If the element is cleaned, it should be washed in a commercial solvent or a detergent and water solution. The element should be saturated in clean engine oil, then squeezed dry before replacing it in the strainer. Be sure to replace the air strainer gasket if the entire air strainer is removed from the compressor intake.
Fig. 10 Dry Element - Pleated Paper Air StrainerDry Element - Pleated Paper Air Strainer
Every two months, 800 operating hours or 20,000 miles whichever occurs first, remove the spring clips from either side of mounting baffle and remove the cover. Replace the pleated paper filter and remount the cleaned cover making sure the filter is in position. Make certain to replace the air strainer gasket if the entire air strainer is removed from the compressor intake.
Fig. 11 Intake AdapterIntake Adapter
When the engine air cleaner is replaced; Some compressors are fitted with intake adapters which allow the compressor intake to be connected to the engine air cleaner, turbo or supercharger. In this case, the compressor receives a supply of clean air from the engine air cleaner. When the engine air filter is changed, the compressor intake adapter should be checked. If it is loose, remove the intake adapter, clean the strainer plate, if applicable, and replace the intake adapter gasket, and reinstall the adapter securely. Check line connections both at the compressor intake adapter and at the engine or engine air cleaner. Inspect the connecting line for kinks and ruptures and replace it if necessary.Compressor Cooling
Every six months, 1800 operating hours or 50,000 miles, whichever occurs first, inspect the compressor discharge port, inlet cavity and discharge line for evidence of restrictions and carboning. If excessive buildup is noted, thoroughly clean or replace the affected parts and closely inspect the compressor cooling system. Check all compressor coolant lines for kinks and restrictions to flow. Minimum coolant line size is 9.5 mm (3/8 inch) I.D. Check coolant lines for internal clogging from rust scale. If coolant lines appear suspicious, check the coolant flow and compare to the tabulated technical data present in the back of this manual.Inspect and clean the external air cooling fins on the cylinder portion of the crankcase. If fins are cracked or broken, replace the compressor.Inspect the air induction system for restrictions.Lubrication
Every six months, 1800 operating hours or 50,000 miles, whichever occurs first; check external oil supply and return lines, if applicable, for kinks, bends, or restrictions to flow. Supply