HOSE 2588539 - Caterpillar

Removal Procedure
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
At operating temperature, the hydraulic oil is hot and under pressure. Hot oils can cause burns.To prevent possible personal injury, release the pressure in the work tool hydraulic circuit (boom, stick, bucket, and swing), travel circuits, and the hydraulic oil tank at the filler cap before any hydraulic lines or components are disconnected or removed.Remove the filler cap only when the engine is stopped and the filler cap is cool enough to touch.
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "Hydraulic System Pressure - Release" in this manual.
Illustration 1 g00536257
Remove five bolts (1), the washers and cover plate (2) under the cab.
Illustration 2 g00542997
This view is from the underside of the cab.
Put identification marks on four hose assemblies (3) for installation purposes.
Oil will drain from four hose assemblies (3) and the auxiliary pilot control valve when the hose assemblies are disconnected from the valve. Place a container under the area of the pilot control valve in order to contain the oil.
Disconnect four hose assemblies (3) from the auxiliary pilot control valve. Put plugs in the ends of the pipe assemblies in order to prevent oil loss and keep contaminants out of the hydraulic system.
Illustration 3 g00543001
This view is from the underside of the cab.
Remove two fittings (4) from the auxiliary pilot control valve. Removing the fittings will provide the clearance that is necessary to remove the valve from the machine.
Illustration 4 g00543023
Remove pedal cover (5) from the pedal plate.
Illustration 5 g00543027
Remove two bolts (6), the washers and pedal plate (7).
Illustration 6 g00543034
Remove rubber bellows (8).
Illustration 7 g00543065
Remove two bolts (9), the washers and auxiliary pilot control valve (10) from the machine.