HOSE AS 2643537 - Caterpillar

Illustration 15 g03091216
Confirm mayday window
Press "Yes" on the screen.A mayday message will be sent to the command center. When received in the command center, the mayday displays as an "Urgent Alarm" pop-up message on every software client session that is running at the time of the event. The event is also captured in the alarm monitor page in the system.Mark a Road Hazard
Illustration 16 g03036156
On-Road Hazard ButtonProximity Awareness on-board provides a method to allow vehicle operators to mark the location of on road hazards that are encountered while in transit. When road hazards are marked, the Cat MineStar System can use the hazard information so AMTs can avoid the hazard.This information explains how to mark a location of a road hazard using Proximity Awareness equipped vehicles.
Communicate to the Cat MineStar System controller the type and location of the hazard.
Push the "On-Road Hazard" button from the list.A pop-up window will appear with a list of hazard types.
Illustration 17 g03385097
Hazard type list
Select the hazard type from the list and press "OK" to confirm.Depending on the type and size of the hazard, survey data may be needed to identify the hazard boundaries and to create a polygon around the hazard. For more information, refer to "Collect and Send Position Data" in this document.
Illustration 18 g03385100
(16) Confirm button (17) Cancel button (18) Undo Button (19) Repositioning Arrows
The plan view window now displays a small box located at the machine origin. Using the on screen repositioning arrows (19), the location of this box can be shifted to better represent the location of the hazard. The shape and size of the box can be adjusted by the controller in the command center.
Press the green check confirm button (16) to create the polygon. Press the red "X" cancel button (17) to cancel.The undo button (18) can be used to undo one movement at a time.Once confirmed, the hazard way point information is sent to the command center. The command center then confirms the location and makes required adjustments to size or shape. At that point, the controller will apply the changes in Site Editor and the hazard information will be sent out as a map update to the all machines.Collect and Send Position Data
This information explains how to use the Proximity Awareness display for survey data collection.
Illustration 19 g03037296
Data collection button
To begin the data collection process, press the data collection button.Note: The recorded data correlates to the corner of the machine body polygon selected. The location of the corners are defined in MineStar by the machine body polygon and may not match the physical corner locations as it is generally configured to be slightly larger than the vehicles true dimensions'.
Illustration 20 g03385114
Select machine position for data window.
A window will appear asking the user to select the machine location that will be used for a base when marking points. Select "OK" after choosing the location.
Illustration 21 g03385105
(20) Record icon
The map display will be outlined in red and a "REC" icon (20) will appear in the upper right corner of the map display when