HOSE AS 2816841 - Caterpillar

start by:a) remove door wiper motor and linkage 1. Remove bracket assembly (2) from wiper linkage assembly (4) as follows: a) Remove spring clip (5), washer (6) and bracket (7).b) Remove bearing (9) with tooling (A) from linkage (8).2. Remove linkages (3) and (4) as follows: a) Remove spring clips (10), washers (12) and pivot assemblies (1) from the linkages.b) Remove bearings (11) from the linkages with tooling (A). 3. Remove retainer (13), the washers and pivot (14) from the bracket. 4. Remove bearings (15) from the pivot with tooling (A).Assemble Door Wiper Linkage
1. Install bearings (1) in pivot (2) with tooling (A). Make sure the bearings are installed even with the outside. 2. Install a washer (4), the pivot, another washer (4) and retainer (3) on bracket (5). 3. Install bearings (8) in linkages (9) and (10) with tooling (A). Make sure bearings are center in the bores.4. Install linkages (9) and (10), washers (11) and clips (6) on pivot assembly (7). 5. Install bearing (14) in the linkage with tooling (A). Make sure bearings are in the center of the bores.6. Install bracket (15) in the linkage.7. Install washer (13) and clip (12) on the bracket.end by:a) install door wiper motor and linkage