HOSE-WATER 2867496 - Caterpillar

Attach Tooling (B) and a suitable lifting device onto pin assembly (13). The weight of Tooling (B) and pin assembly (13) is approximately 104 kg (230 lb). Use Tooling (B) in order to remove pin assembly (13). Remove shims (14).
Remove boom (11). The weight range of boom (11) and the stick cylinder is approximately 1500 kg to 3000 kg (3300 lb to 6615 lb). Installation Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 9U-6225 Pin Driver Cap 1
C 452-6006 Grease -
D 369-9451 O-Ring Assembly Compound - Note: Make sure that the pin bores in the boom and the pin bores in the upper frame are clean and free of dirt and debris prior to installing the boom in the upper frame.
Illustration 10 g03892527
Illustration 11 g03892532Note: Apply a thin coat of Tooling (C) to the bores in the upper frame and in the bore for the boom foot pin assembly. Apply a thin coat of Tooling (C) to the lip of lip seals.
Install retainer plate (4) on the boom cylinder pin. Install bolts (3). Attach a suitable lifting device onto boom (11). The weight range of boom (11) and the stick cylinder is approximately 1500 kg to 3000 kg (3300 lb to 6615 lb). Place the boom in position in the upper frame of the machine. Make sure that the pin bores in the upper frame align with the pin bore in the boom.
Illustration 12 g03892598Note: Apply a thin coat of Tooling (C) to the boom foot pin assembly.
Install pin assembly (13) in the upper frame and in the boom.
Illustration 13 g03892712
(X) Upper Frame
(Y) Boom
(Z) Boom Foot Pin Assembly
Measure the total clearance between the boom and the upper frame at the bore for the boom foot pin assembly. The total clearance of Dimension (a) plus Dimension (b) must not be more than 0.80 mm (0.030 inch). If the total clearance is less than 0.80 mm (0.030 inch), the addition of shims between the boom and the upper frame will not be required. If the total clearance is more than 0.80 mm (0.03 inch), add the correct thickness of shims in order to obtain the required clearance.
Install the correct number of shims (14).
Illustration 14 g03892538Note: Apply a thin coat of Tooling (C) onto pin assembly (20).
Install pin assembly (13) in the upper frame and in the boom.
Install bolt (12) in pin assembly (13). Tighten bolt (12) to a torque of 325 40 N m (240 30 lb ft).
Remove the suitable lifting device from the boom.
Illustration 15 g03892522
Connect harness assembly (10).
Illustration 16 g03892508
Connect hose assemblies (9). Connect hose assemblies (8). Connect hose assemblies (7).
Illustration 17 g01320263
Use a suitable lifting device in order to raise boom cylinder (2). The weight of boom cylinder (2) is approximately 204 kg (450 lb). Use Tooling (A) and a suitable hammer in order to drive pin (6) into boom cylinder (2).
Illustration 18 g01320261
Install shims (5), retainer plate (4), and bolts (3) in order to secure boom cylinder (2). Tighten bolts (3) to a torque of 240