AVSPARE.COM
parts catalog

HOSE-RADIATOR 2894875 - Caterpillar


2894875 HOSE-RADIATOR Caterpillar parts M318D, M322D, M322D MH
Rating:
59
Alternative (cross code) number:
CA2894875
289-4875
2894875
Caterpillar 2894875 HOSE-RADIATOR
Weight: 1 pounds 0 kg.

Buy HOSE-RADIATOR 2894875 Caterpillar genuine, new aftermarket tractor parts with delivery
WHEELED EXCAVATOR,

Compatible equipment models: 2894875:

WHEELED EXCAVATOR  M318D   M322D   M322D MH   Caterpillar
Number on catalog scheme: 18
  For full view, you need register

Information:


Illustration 1 g01400260
Connections of the position sensor for the winchThis diagnostic code is associated with the position sensor for the winch. The FMI 08 means that the ECM has determined that the signal frequency or the signal pulse width is not within the expected range. The sensor is a PWM sensor that operates at a frequency of approximately 500 hertz. The sensor has an operating duty cycle of 5% to 95%.The possible causes of this diagnostic code are listed below:
The sensor has failed.
Intermittent connections or poor connections
Mechanical devices are loose.
The ECM has failed. This is unlikely.Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all of the connections in the circuit are clean and secure. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure.Note: The following test procedure may create other diagnostic codes. Ignore these created diagnostic codes and clear the diagnostic codes when the original diagnostic code has been corrected. Ensure that the diagnostic code of CID 1881 FMI 08 is active before performing this procedure.Note: Use a digital multimeter for the measurements in this procedure. Test Step 1. CHECK FOR POWER AT THE SENSOR.
Do not disconnect the harness connector from the sensor.
At the back of the harness connector for the sensor, insert a multimeter probe along contact 1 (wire 709-OR) for the voltage supply.
At the back of the harness connector for the sensor, insert a multimeter probe along contact 2 (wire J764-BR) for the ground.
Turn the key start switch and the disconnect switch to the ON position.
Measure the voltage from contact 1 (wire 709-OR) to contact 2 (wire J764-BR).Expected Result:The voltage is 10 0.5 DCV.Results:
OK - The voltage is 10 0.5 DCV. Proceed to Test Step 3.
NOT OK - The voltage is not 10 0.5 DCV. The circuit is open. Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE SIGNAL CIRCUIT OF THE SENSOR.
Turn the key start switch and the disconnect switch to the OFF position.
At the back of the harness connector for the sensor, remove the multimeter probe from contact 1 (wire 709-OR) and insert the probe along contact 3 (wire G942-OR).
The other multimeter probe remains at the ground wire contact 2 (wire J764-BR).
Turn the disconnect switch and the key start switch to the ON position.
Monitor the signal of the sensor with the multimeter.
Without disconnecting the sensor or the hardware that is associated with the sensor from the machine, take the sensor through the full operating range of the sensor.Expected Result:The sensor's signal responds in the manner that is described at the beginning of this procedure.Results:
OK - The sensor's signal responds correctly. The sensor is operating correctly. Proceed to Test Step 3.
NOT OK - The sensor's signal does not respond correctly. The sensor has failed.Repair: Replace the joystick. Calibrate the joystick if it

Caterpillar parts catalog:

Caterpillar parts catalog
M318D Excavator W8P00001-UP (MACHINE) POWERED BY C6.6 Engine
M322D Excavator W2S00001-UP (MACHINE) POWERED BY C6.6 Engine
M322D Material Handler W2T00001-UP (MACHINE) POWERED BY C6.6 Engine
M318D Excavator D8W00001-UP (MACHINE) POWERED BY C6.6 Engine
M322D Excavator D2W00001-UP (MACHINE) POWERED BY C6.6 Engine
M322D Material Handler D3X00001-UP (MACHINE) POWERED BY C6.6 Engine
M318D Wheeled Excavator P8L00001-UP (MACHINE) POWERED BY C6.6 Engine
M322D Wheeled Excavator P2T00001-UP (MACHINE) POWERED BY C6.6 Engine
M322D MH Wheeled Excavator P3W00001-UP (MACHINE) POWERED BY C6.6 Engine
M320D2 Wheeled Excavator EN800001-UP (MACHINE) POWERED BY C7.1 Engine
M322D2 Wheeled Excavator EN200001-UP (MACHINE) POWERED BY C7.1 Engine
M324D2 MH Wheeled Excavator EN300001-UP (MACHINE) POWERED BY C7.1 Engine


Parts hose Caterpillar catalog:

5P1442 HOSE
120B, 120G, 120H, 120H ES, 120H NA, 120M, 120M 2, 12G, 12M, 12M 2, 12M 3, 12M 3 AWD, 130G, 135H NA, 140B, 140G, 140M, 140M 2, 140M 3, 140M 3 AWD, 14G, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 215, ...
5P0767 HOSE
1090, 1190, 1190T, 120G, 1290T, 1390, 140G, 215, 215B, 215C, 215D, 225, 225D, 227, 229, 2290, 229D, 231D, 235, 235B, 235C, 235D, 236D, 2384C, 2390, 2391, 242D, 245, 245B, 245D, 246D, 2470C, 2484C, 249...
5P1420 HOSE
120M, 12M, 216, 216B, 216B3, 226B, 226B3, 228, 2290, 232B, 235C, 236, 236B, 236B3, 236D, 2384C, 2390, 2391, 242B, 242B3, 242D, 246C, 246D, 247, 247B, 247B3, 248, 2484C, 2491, 252B, 252B3, 256C, 257B, ...
8C3681 HOSE
120K, 120K 2, 120M, 120M 2, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 140G, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 16H, 16H NA, 225D, 231D, 236D, 242D, 2...
1856792 HOSE AS
M318C, M318C MH, M318D, M318D MH
2126763 HOSE AS
M318C, M318C MH, M318D, M318D MH, M322C, M322D, M322D MH
7T3158 HOSE AS
12H, 12H ES, 12H NA, 140H, 140H ES, 140H NA, 143H, 14H NA, 160H, 160H ES, 160H NA, 163H NA, 16H NA, AP-1000, AP-1050, CB-22, D7H, D8N, M318C, M318C MH, M318D MH, M322C, M322D MH
2465863 HOSE AS
M315D, M316C, M316D, M318C, M318D
2754945 HOSE
M316D, M318D, M318D MH, M322D, M322D MH
3400261 HOSE AS
M316D, M318D, M318D MH, M322D, M322D MH
1660357 HOSE AS
583T, 587T, 815F II, 816F II, D350E, D400E, D8N, D8R, D8T, M318D MH, M322D, M322D MH, PL83, PL87
2610713 HOSE-RADIATOR
M318D, M322D, M322D MH
2942003 HOSE AS
M313D, M315D, M316D, M318D, M322D
3439725 HOSE AS
M313D, M315D, M316D, M318D, M322D
3346621 HOSE AS
M313D, M315D, M315D 2, M316D, M317D 2, M318D, M318D MH, M322D, M322D MH
2536923 HOSE AS
M313D, M315D, M315D 2, M316D, M317D 2, M318D
2536922 HOSE AS
M313D, M315D, M315D 2, M316D, M317D 2, M318D, M318D MH, M322D, M322D MH
2802434 HOSE AS
M318D, M318D MH, M322D, M322D MH
2802433 HOSE AS
M318D, M318D MH, M322D, M322D MH
2802435 HOSE AS
M318D, M318D MH, M322D, M322D MH
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.