HOSE AS 2988518 - Caterpillar

Illustration 1 g00741065
Location of "Cut" Button
Press and hold the "Cut" button on the left keypad.
Release the "Cut" button when the saw bar has completely rotated to the OUT position.Note: The return speed of the saw bar must be set as fast as possible without damaging the saw bar. To adjust the return speed of the saw bar, perform Steps 5 through 8.
Lower the harvester head to the ground. Turn the attachment switch to the OFF position. Lower the hydraulic activation control lever. Stop the engine. Remove the valve cover from the harvester head.
The speed of the functions on the harvester head must be set correctly. If the speeds are set too fast damage to the harvester head may result. Adjust the speeds of the functions according to the following procedure to prevent damage to the harvester head.
Illustration 2 g00696094
Side View of Main Control Valve ( HH45/HH55/HH65) (1) Saw (RETURN).
Illustration 3 g00696129
Side View of Main Control Valve ( HH75) (1) Saw (RETURN).
Loosen the locknut on the stroke limiter screw for saw RETURN (1). Turn the adjusting screw clockwise in order to decrease the speed of the function. Turn the adjusting screw counterclockwise in order to increase the speed of the function.
Start the engine. Raise the hydraulic activation control lever. Turn the engine speed dial to position "8". Turn the attachment switch to the ON position. Activate the function again in order to test the new setting of the stroke limiter screw. Tighten the locknut when the speed has been set correctly. The cycle time of the saw bar should be within 1.0 to 1.5 seconds.Note: The speed of saw bar EXTEND is not adjustable. Only the speed of the saw bar RETURN can be adjusted.
Lower the harvester head to the ground. Turn the attachment switch to the OFF position. Lower the hydraulic activation control lever. Stop the engine. Install the valve cover on the harvester head.