HOSE AS 2V4361 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 9S-8871 Seal Locator 1
9S-8890 Bolt 3
2P-1956 Bolt(1) 3
6V-7876 Installer 1
9S-8858 Installer Nut 1
(1) For use on engines equipped with a rear crankshaft gear
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Note: Once the seal and the wear sleeve are separated, these components cannot be used again. Refer to Special Instruction, SMHS8508 before the seal is serviced.Note: Do not use any type of lubricant during the installation of the crankshaft seal and wear sleeve.Note: Before installing the wear sleeve, inspect the crankshaft for scratches or any distortion on the surface of the crankshaft that may lead to an out of round condition. Use a polishing cloth to clean the imperfections on the crankshaft.
Illustration 1 g00517174
Install crankshaft rear seal (6) and wear sleeve (1) with Tool (A), as follows:
Use 4C-9500 Quick Cure Primer to clean the outside diameter of crankshaft (3) and the inside diameter of wear sleeve (1).
Apply 4C-9507 Retaining Compound to the outside diameter of crankshaft (3). Apply 4C-9507 Retaining Compound to the inside diameter of wear sleeve (1).
Put 9S-8871 Seal Locator (2) in position on crankshaft (3). Install three 9S-8890 Bolts that hold the seal locator in position on the crankshaft.
Install wear sleeve (1) and seal (6) on crankshaft (3). Put 6V-7876 Seal Installer (4) on 9S-8871 Seal Locator (2). Lubricate the face of 9S-8858 Installer Nut (5) and the washer. Install 9S-8858 Installer Nut (5) and the washer on 9S-8871 Seal Locator (2).
Tighten 9S-8858 Installer Nut (5) until 6V-7876 Seal Installer (4) contacts 9S-8871 Seal Locator (2).
Remove Tool (A) and check the crankshaft seal and the wear sleeve for the correct installation.End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".