HOSE ASSEM. 2V4725 - Caterpillar

Configure the Machine Type
You can configure a new machine with the "Machine Settings" dialog.
Start the Display (1) in Service mode.
From the "Setup Menu - Configuration" dialog, press the "Installation" Hard Key in order to list the items under the "Setup Menu - Installation" dialog.
Illustration 1 g01669473
Use the down Arrow Key or the up Arrow Key until "Machine Settings" is highlighted. Press the "OK" key. A dialog that is similar to Illustration 1 appears.
Illustration 2 g01378900
Press the "Edit Machine" Hard Key.A dialog that is similar to Illustration 2 appears.
Illustration 3 g01378900
Input the name of the machine. Press the arrow soft key.A dialog that is similar to Illustration 3 appears.
Illustration 4 g01378903
Use the down Arrow Key or the up Arrow Key until "Grader" is highlighted. Press the "OK" key.A dialog similar to Illustration 4 appears.
Illustration 5 g01670234
Select the "System Type". Press the "OK" key.A screen that is similar to Illustration 5 appears.
Illustration 6 g01670319
Select the type of mast that for the left side of the machine. Press the "OK" key.A screen that is similar to Illustration 6 appears.
Illustration 7 g01670354
Select/deselect the fixed sensors that are mounted on the machine by pressing the swap soft key.
Press the "OK" key.
Illustration 8 g01670413
For GPS and "UTS" systems, use the down arrow key or the up arrow key until the desired "Radio Type" is highlighted. Press the "OK" key.Select "TCXXXC/CRXXXC". Caterpillar systems normally use the TC series data radio or the CR series data radio.If a third party radio is selected, the data is passed over RS232. Refer to "Customer Supplied Radio" section that is within this document.
Press the "OK" key.
Illustration 9 g01670753
Choose the type of "Grade Control". Press the "OK" key.If "Indicate" is chosen, proceed to Step 16.
Illustration 10 g01751973
Select the "Caterpillar A4:M1" for the Lift Valve module.
Illustration 11 g01751975
Choose the "Auto Controls Range Limit".Caterpillar recommends the default value.
Illustration 12 g01310339
Use the down Arrow Key or the up Arrow Key until the desired "Lightbar" option is highlighted.
Illustration 13 g01310346
Review the selections. Press the "OK" key in order to save the settings.
Press the Escape key in order to exit the "Setup Menu - Installation" dialog. The changes take effect immediately.