HOSE AS 3197925 - Caterpillar

Customize the AccuGrade Laser System
The Customize menu is contained within the Configuration menu. This menu lets you customize the AccuGrade Laser with the items in the following menus:Select the Operating Mode
Toggle either the right mast elevation/menu scroll switch or the left mast elevation/menu scroll switch until Customize is highlighted on the Display.
Illustration 4 g00994416
Press the OK/right reset button in order to access the Customize menu. Operating Mode is highlighted by default. A screen similar to Illustration 4 appears.
Illustration 5 g00994494
Display screen for Dual Mast system
Illustration 6 g01036414
Display screen for Single Mast system
Press the OK/right reset button in order to access the Operating Mode menu. A screen similar to Illustration 5 appears for the Dual Mast System. A screen similar to Illustration 6 appears for the Single Mast System.
Toggle either the right mast elevation/menu scroll switch or the left mast elevation/menu scroll switch until the mode that is required is highlighted on the "Display".
Press the OK/right reset button in order to save the changes and exit back to the Customize menu.In order to exit back to the Customize menu without saving any changes, press the ESC/left reset button.Set The Elevation Offset
The Elevation Offset menu allows you to set the amount each toggle of the Elevation Offset switch on the remote switch assembly increases or decreases the reference elevation. This allows you to move the blade a certain distance in the upward or downward direction with the toggle of a switch.
Toggle either the right mast elevation/menu scroll switch or the left mast elevation/menu scroll switch until Elevation Offset is highlighted on the display.
Illustration 7 g00994498
Press the OK/right reset button in order to access the Elevation Offset menu. A screen similar to Illustration 7 appears.
Press the cursor scroll button in order to move the cursor to the right and highlight the digit that you want to change.
Do one of the following.
Toggle either the right mast elevation/menu scroll switch or the left mast elevation/menu scroll switch UP in order to increase the highlighted value.
Toggle either the right mast elevation/menu scroll switch or the left mast elevation/menu scroll switch DOWN in order to decrease the highlighted value.
Press the OK/right reset button and the ESC/left reset button simultaneously in order to set the elevation offset to the default value of 0.030m.Repeat step 3 and step 4 until the elevation offset is set to the desired value.
Press the OK/right reset button in order to save the changes and exit to the Customize menu.In order to exit back to the Customize menu without saving any changes, press the ESC/left reset button.
Illustration 8 g01096663
Guidance screen for Dual Mast system
Illustration 9 g01066370
Guidance screen for Single Mast system
Move the power/setup switch to ON position. This causes the guidance screen to be shown on the DisplayA screen similar to Illustration 8 will be shown for the Dual Mast system.A screen similar to Illustration 9 will be shown for the Single Mast system.Configure the Display for Single Mast Operation
Illustration 10 g01075178
Use the right mast elevation/menu scroll switch in order to toggle through the Installation menu until Control Mode