HOSE AS 3225314 - Caterpillar

Removal Procedure
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component must be cleaned. Cleaning will help to prevent dirt from entering the internal mechanism.
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting, and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Dealer Service Tool Catalog" for tools and supplies suitable to collect and contain fluids on Cat® products.Dispose of all fluids according to local regulations and mandates.
Hot oil and hot components can cause personal injury. Do not allow hot oil or hot components to contact skin. At operating temperature, the engine coolant is hot and under pressure.Steam can cause personal injury.Check the coolant level only after the engine has been stopped and the cooling system pressure cap is cool enough to touch with your bare hand.Remove the cooling system pressure cap slowly to relieve pressure.Cooling system conditioner contains alkali. Avoid contact with the skin and eyes to prevent personal injury.
Drain the coolant. Refer to Operation and Maintenance Manual, "Cooling System Coolant (ELC) - Change" for the correct draining and filling procedures.
Illustration 1 g01206371
Open engine hood (1).
Illustration 2 g01206731
Remove bolts (2) and plate (3).
Illustration 3 g03828479
Remove tube assembly (4), hose (5), and hose (6).
Illustration 4 g03828515
Disconnect hose assemblies (7), (8), and (9).
Illustration 5 g03828518
Loosen clamp (10) and disconnect hose.
Illustration 6 g03828523
Disconnect tube assembly (11).
Illustration 7 g03828526
Remove nuts (13), turbocharger (12), and gasket (14).Installation Procedure
Install turbocharger (12) in the reverse order of removal.