HOSE AS 3247596 - Caterpillar

Removal Procedure
Table 1
Required Tools    
Tool    Part Number    Part Description    Qty    
A     FT-1114     Vacuum Cap     1    
5P-0306 Vacuum Transducer     1    
6V-4142 Fitting     1    
5K-5068 Fitting     1    Start By:
Release the hydraulic system pressure. Refer to Disassembly and Assembly, "System Pressure - Release".
Connect the steering frame lock. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Care must be taken to ensure that fluids are contained during performance of inspection, maintenance, testing, adjusting and repair of the product. Be prepared to collect the fluid with suitable containers before opening any compartment or disassembling any component containing fluids.Refer to Special Publication, NENG2500, "Caterpillar Tools and Shop Products Guide" for tools and supplies suitable to collect and contain fluids on Caterpillar products.Dispose of all fluids according to local regulations and mandates.
Note: Cleanliness is an important factor. Before the disassembly procedure, the exterior of the component should be thoroughly cleaned. This will help to prevent dirt from entering the internal mechanism.Note: Put identification marks on all lines, on all hoses, on all wires, and on all tubes for installation purposes. Plug all lines, hoses, and tubes. This helps to prevent fluid loss and this helps to keep contaminants from entering the system.
Illustration 1 g01172128
Remove the hydraulic tank cap and install Tooling (A). Apply 276 kPa (40 psi) to 414 kPa (60 psi) of air pressure to Tooling (A) .
Illustration 2 g01172138
Raise hood (1) and rotate roading fender (2) outward.
Illustration 3 g01172139
Remove panel assembly (3) .
Illustration 4 g01172171
Disconnect tube assembly (4) .
Disconnect harness assemblies (5) .
Disconnect hose assemblies (8) .
Remove bolts (6) and control manifold (7) .