HOSE 3327786 - Caterpillar

Changing the Heating Cycle for a Single Heating Cycle
When unit is operating in the heat mode, press arrow key (9) to decrease the cycle or press arrow key (10) to increase the cycle.Changing the Heating Cycle Permanently
When the unit is not operating in the heat mode, press and hold arrow key (9) for 3 seconds until the display appears and flashes. Release arrow key (9). Now set the heating cycle from 10 to 120 minutes by using arrow key (9) and (10) .The new heating cycle has been stored when the display disappears.Manually Starting the Preheat System with the Engine Start Switch in the ON Position
Press on/off key (8) in order to start the preheat system. The preheat system will remain on until the engine start switch is turned to the OFF position.After the engine start switch is turned to the OFF position, the preheat system will remain active for 15 minutes. The time period can be decreased by pressing arrow key (9). The minimum time period is 1 minute. The time period can be increased by pressing arrow key (10). The maximum time period is 120 minutes. Press on/off key (8) again in order to shut off the preheat system. The fan automatically continues to operate in order to cool down the heater.Programming the Preselected Start Times and Days
Three different start times within a 24 hour period can be programmed into the preheat system. The preheat system can also be programmed to start once in seven days. Note: Only one start time can be activated at any given time.Select Memory and Activate
Press select key (7) once for memory information 1. Press the key twice for memory information 2. Press the key three times for memory information 3.Continue to press select key (7) until no memory is displayed. When no memory is displayed, the memory is not activated.Start Heating within 24 Hours
Start the Heating within 24 Hours.Set the preselected time - Press select key (7) until the required memory information (2) flashes on display (1). Press arrow key (9) or (10). The preset time flashes on display (1). Use arrow key (9) or (10) to set the preselected time for heating.Note: Setting the time is only possible when the preselected time on display (1) is flashing. Press select key (7) in order to renew a selection.Start Heating after 24 Hours
Set a preselected time - Press select key (7) until the required memory information (2) flashes on display (1). Press arrow key (9) or (10). The preset time flashes on display (1). Use arrow key (9) or (10) to set the preselected time for heating. Set a preselected day. Set a preselected day - The preselected day starts to flash approximately 5 seconds after the preselected time is set. Use arrow key (9) or (10) in order to set the preselected day for heating.The preselected time and the day are stored when the time on the display disappears. The memory information indicates the activated memory. A flashing heating (symbol)