HOSE AS 3328924 - Caterpillar

Table 1
VIMS Service Operations    
Service Operation    Service Program Code    Service Program Code No.    
Attachment Code - Configure     "ATTACH"     288224    
Calibration Modes - Enter     "SERV"     7378    
Data Logger - Reset     "DLRES"     35737    
Data Logger - Start/Stop     "DLOG"     3564    
Display Backlighting - Set     "BLT"     258    
Display Contrast - Set     "CON"     266    
Display Language - Set     "LA"     52    
Display Units - Set     UN     86    
Event - Configure (9.6X or later)     "ESET" (1)     3738    
Events Acknowledged - Show     "EACK"     3225    
Event List - Show     "ELIST"     35478    
Event Recorder - Start     "EREC"     3732    
Events Statistics - Show     "ESTAT"     37828    
Lubrication Cycle Times - Set     "LUBSET"     582738    
Lubrication Manual - Start     "LUBMAN"     582626    
Machine Status - Show     "MSTAT"     67828    
Odometer - Set     "ODO" (1)     636    
Resettable Totals - Reset (LHEX/OHT)     "RESET"     73738    
Resettable Totals - Show (LHEX/OHT)     "TOT"     868    
Service Lamp - Reset     "SVCLIT"     782548    
Service Lamp - Set (9.5X or later)     "SVCSET" (1)     782738    
Snapshot Trigger- Configure (9.5X or later)     "ERSET" (1)     37738    
System Self Test     "TEST"     8378    
Truck Payload - Calibrate     "PAYCAL" (1)     729225    
Truck Payload - Configure     "PAYCONF" (1)     7292663    
( 1 ) The service tool is required to be connected and communicating with the machine before this SPC is active.Each service program code is a unique number of one to ten digits that abbreviates this operation. The service program codes have a letter equivalent that describes the service operation. This letter equivalent makes remembering the service program code for each operation easier. The English letter equivalent for each service program code is shown in parentheses. The same service program codes are used regardless of the onboard language. After entering the service program code on the keypad, this request will begin after the "OK" key is pressed. This command must be activated within five seconds of entering the last SPC character. The maximum delay that is allowed between the entry of the SPC characters is five seconds.