3334533 HOSE AS Caterpillar parts
330D, 330D FM, 330D L, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
Rating:
Alternative (cross code) number:
CA3334533
333-4533
3334533
CA3334533
333-4533
3334533
EXCAVATOR, MOBILE HYD POWER UNIT,
Compatible equipment models: 3334533:
Number on catalog scheme:
8
For full view, you need register
Information:
All solenoid return wires are joined. The wires also connect to connector A-A2 (wire 202-BK-16) of the ARC.Note: The approximate coil resistance of the solenoid valves is 29.8 1.0 ohms at 25.0 °C (77.0 °F).This diagnostic code is recorded when the ARC reads the current of the solenoid circuit as being below normal range (open circuit).Note: This procedure can cause new diagnostic codes to be recorded. Ignore these created diagnostic codes. Complete the following procedure. Then clear the created diagnostic codes.
CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine. Ensure that the CID and the FMI for the solenoid are active.
Place the parking brake switch in the OFF position.
Place the ARC in the detect fault mode (mode 1). The readout should display CID 0710 FMI F05. Ensure that the fault is still active.
Disconnect the supply solenoid from the machine harness.
At the machine harness connector for the solenoid that is being tested, install a jumper. The jumper should be installed from the signal contact wire (D989-BU-16) to the return contact wire (202-BK-16).
Observe the status of the diagnostic code. The diagnostic code is active or the diagnostic code is NOT active.Expected Result: The status of the diagnostic code is active and the status of the diagnostic code is NOT active as the jumper is installed and then removed.Results:
OK: The circuit is correct. The solenoid is faulty. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. STOP.
NO: The diagnostic code remains active.
CHECK THE SOLENOID.
Turn the disconnect switch and the key start switch to the ON position. Do not start the engine. Ensure that the CID and the FMI for the solenoid are active.
Place the parking brake switch in the OFF position.
Place the ARC in the detect fault mode (mode 1). The readout should display CID 0710 FMI F05. Ensure that the fault is still active.
Disconnect the supply solenoid from the machine harness.
At the machine harness connector for the solenoid that is being tested, install a jumper. The jumper should be installed from the signal contact wire (D989-BU-16) to the return contact wire (202-BK-16).
Observe the status of the diagnostic code. The diagnostic code is active or the diagnostic code is NOT active.Expected Result: The status of the diagnostic code is active and the status of the diagnostic code is NOT active as the jumper is installed and then removed.Results:
OK: The circuit is correct. The solenoid is faulty. Repeat this test "CHECK THE SOLENOID" in order to verify the solenoid failure. Replace the solenoid. STOP.
NO: The diagnostic code remains active.
Caterpillar parts catalog:
Parts hose Caterpillar catalog:
330C, 330C FM, 330C L, 330D, 330D FM, 330D L, 330D LN, 336D, 336D L, 336D LN, 385B, 385C L, 385C L MH
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E L, 340D L, 340D2 L
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
325C, 330C, 330C FM, 330C L, 330D, 330D FM, 330D L, 330D LN, 336D, 336D L, 336D LN
330D, 330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E, 336E H, 336E L, 336E LH, 336E LN, 336F L
325C, 330C, 330C L, 330D, 330D FM, 330D L, 330D LN, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
2892421
HOSE AS
330D, 330D L, 336D L, 336D LN
330D, 330D L, 336D L, 336D LN
3371157
HOSE AS
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
3371161
HOSE AS
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
3371165
HOSE AS
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
2608197
HOSE AS
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
2551753
HOSE AS
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D LN
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D LN
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
2666189
HOSE
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 340D L, 340D2 L, M330D
330D, 330D FM, 330D L, 330D LN, 330D MH, 336D, 336D L, 336D LN, 336D2, 336D2 L, 336E L, 340D L, 340D2 L