HOSE-AIR 3501731 - Caterpillar

Illustration 4 g03673394
Illustration 5 g03673397
Install one terminal of new ground wire assembly (1) in between the nut (2) and the stud (3).
Tighten the nut (2) to 47 N m (35 lb ft).
Illustration 6 g03673398Note: Before assembling ground wire assembly (1), scrape paint off and clean the surface of terminal for good continuity.
Install other terminal of ground wire assembly (1) to generator bottom along with one new bolt (4), one new lockwasher (5), two new washers (6), and one new nut (7).
Tighten nut (7) to 12 N m (106 lb in). Procedure to Install New Circuit Breaker Assembly On AP1000E and AP1055E Asphalt Pavers
Table 3
New Parts List
Item Qty Part Description
1 4 448-1980 Circuit Breaker As
Illustration 7 g03673399
Replace the former four 25A GFCI 254-5092 Circuit Breaker As with four new standard 448-1980 Circuit Breaker As (1) as shown in Illustration 7.
Remove the 4D-7794 Clip mounts that held the white neutral wires and discard the part. Note: If there is a 20A or 30A breaker next to these four breaker assemblies, breaker must remain GFCI to protect the auxiliary power box.Procedure to Change the Grounding Location in AS3301C, AS3251C, and AS2302C Asphalt Screeds
Table 4
New Parts List
Item Qty Part Description
1 1 452-7654 Cover As
2 1 367-6889 Ground Wire As
3 1 7P-1695 Washer
6 2 8T-4121 Hard Washer
8 1 4D-1326 Lockwasher
7 1 8T-4133 Nut
Illustration 8 g03673402
Replace the former 279-5689 Plate with new 452-7654 Cover As (1).
Illustration 9 g03673403
Install one terminal of new ground wire assembly (2) along with one new washer (3) to grounding stud inside the relay box.
Tighten the nut (4) to 55 N m (41 lb ft).
Illustration 10 g03673404
Install other terminal of ground wire assembly (2) along with one new hard washer (6), one new lockwasher (8), and one new nut (7) to 110-2023 Weld Stud (5) on inside of cover assembly (1).
Tighten nut (7) to 55 N m (41 lb ft).