HOSE 3504308 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0520 Driver Group 1
Keep all parts clean from contaminants.Contaminants may cause rapid wear and shortened component life.
Illustration 1 g01134277
Install sleeve bearing (12) in the flywheel housing with Tooling (A). The split in the sleeve bearing should be located at Angle (Y), which is 15 1 degrees from the vertical centerline. The bearing should be installed to Depth (Z), which is 2.0 0.5 mm (0.08 0.02 inch).
Install cover (10) and the bolts on the back side of the flywheel housing.
Illustration 2 g01134279
Install sleeve bearing (11) in the flywheel housing with Tooling (A). The split in the sleeve bearing should be located at Angle (X), which is 15 1 degrees from the horizontal centerline. The bearing should be installed to Depth (Z), which is 2.0 0.5 mm (0.08 0.02 inch).
Install cover (9) and the bolts on the back side of the flywheel housing.
Illustration 3 g01134263
Use Tooling (A) and install sleeve bearing (8) in adapter (2). Install the O-ring seal on the adapter.
Illustration 4 g01134262
Position gear assembly (6) and gear assembly (7) in the flywheel housing.
Illustration 5 g01115921
Position idler gears (5) and retainer assemblies (4). Install bolts (3). Tighten bolts (3) to a torque of 100 20 N m (74 15 lb ft).
Lubricate the O-ring seal on the adapters with clean engine oil. Position adapters (2) on the flywheel housing and install bolts (1). End By:
Install the flywheel. Refer to Disassembly and Assembly, "Flywheel - Install".