HOSE AS 3507377 - Caterpillar

Illustration 29 g03367916
New faceplate ready to install on the joystick
Before proceeding to the next Step 28, reinspect and verify the following:
All connectors are properly oriented and fully seated into the board connectors.
All connectors are greased to assure a complete environmental barrier.
All three harnesses are properly routed, not twisted, and harnesses (14) and (15) are secured with cable ties.
Inspect the faceplate and inside the handle for any contamination (such as cut cable tie pieces). Remove any stray objects or contamination inside the handle.
Illustration 30 g03367920
Illustration 31 g03368474
Position the bottom lip of the faceplate inside the handle opening as shown in Illustration 30.Note: The 4-wire harness cable (18) should be lightly folded as shown in Illustration 31 for self stowing in the head space.
Illustration 32 g03368476
Gently push wiring down during faceplate closure.
Illustration 33 g03368478
Ensure that the wires are not in a pinch point.
Illustration 34 g03368479
Ensure that the wires are not seen in screw holes before faceplate closure and after the faceplate is seated on the handle.
Gently push all harness wires inward and away from the faceplate edge to clear the handle perimeter. Refer to Illustration 32. Once the harness wires are correctly positioned, close the faceplate. View the two screw holes on the back of the handle. Verify that the wires are not pinched in the screw hole. Hold the faceplate closed until the original two screws are installed and seated.
Two spare screws are provided in the kit. Using the two original screws or the provided screws, install the two screws (4) in the holes. Using torque screwdriver, or a similar torque driver, lightly torque each screw to seat the screws. Then, torque the screws to 0.6 N m to 1.1 Nm (5 lb in to 10 lb in). Do not over torque the screws. Correct torque will ensure that the screws are properly seated. Inspect both screws to assure they are seated. Inspect the faceplate seams on the handle to assure the faceplate is seated.
Illustration 35 g03368482
Illustration 36 g03368483
Label
Disconnect the 4-pin wrist strap connector from joystick connector. Remove the alligator clip from the ESD sheet. The wrist strap can be removed from the wrist. Apply the supplied label (Illustration 36) to the black section (19) of the joystick base in the position shown in Illustration 35. The label indicates that this procedure has been performed on this joystick.
Remove any excess grease on the handle with the moist towelette or paper towel.
Illustration 37 g03368486
Check all five faceplate push-button functions
Illustration 38 g03368487
Check function of three positions of FNR switch
Illustration 39 g03368490
Check articulation function in both directions
Reinstall the joystick. Refer to Illustration 37 to 39. Start the engine. Before operating the machine, test and verify that the following joystick functions operate as expected through the full operating range:
Machine articulation
Wheel lean (left and right switches)
Forward, Neutral, Reverse (FNR) trigger switch
Neutral articulation switch
Transmission up/down shift switches
Blade lift/lower
Steering functionality
If any of the joystick functions do not respond to the manual commands as expected, replace the joystick.
Once all joystick functions are verified to be operating properly, the procedure is complete.