HOSE AS 3588757 - Caterpillar

Illustration 29 g01089993
Apply Tooling (P) to the threads of bolts (40). Install bolts (40) into bevel and transfer gear (2). Tighten bolts (40) to a torque of 135 20 N m (100 15 lb ft).
Illustration 30 g01101603
Reposition the bevel and transfer gear housing (2) so that shaft assembly (47) is in the vertical position. Install bearing cone (39).
Illustration 31 g01089988
Lower the temperature of bearing cup (38). Install bearing cup (38).
Illustration 32 g01089985
Lower the temperature of bearing cup (37). Install bearing cup (37).
Illustration 33 g01101605
Install original shim pack (36) and cage (35).
Illustration 34 g01101606
Install spacer (33).
Illustration 35 g01101607
Install bearing cone (32).
Illustration 36 g01101608
Install washer (31). Apply Tooling (Q) to the threads of shaft assembly (47).
Illustration 37 g01101628
Apply Tooling (T) to the threads and face of spanner nut (29). Install lock washer (30) and spanner nut (29).
Illustration 38 g01101629
Use Tooling (B), Tooling (D), and Tooling (J) to tighten spanner nut (29). Tighten spanner nut (29) to a torque of 2375 300 N m (1752 220 lb ft).
Illustration 39 g01101632
Bend the tab on lock washer (30) into the slot on spanner nut (29).
Illustration 40 g01101634
Install bolts (34). Tighten bolts (34) to a torque of 135 20 N m (100 15 lb ft).
Illustration 41 g01101637
Use Tooling (K) to check the backlash. Check the backlash in three places. The backlash measurements that were found in the three positions should not vary any more than 0.15 mm (0.006 inch).
The backlash should be 0.36 0.12 mm (0.014 0.005 inch).
Illustration 42 g01101642
Adjust shims (36) to obtain the proper backlash. When the proper backlash is achieved, remove bolts (34). Apply Tooling (P) to the threads of bolts (34). Install bolts (34). Tighten bolts (34) to a torque of 135 20 N m (100 15 lb ft).
Remove Tooling (M).End By:
Connect the transmission and bevel gears. Refer to Disassembly and Assembly, "Transmission and Bevel Gears - Connect".