HOSE AS 3614654 - Caterpillar

Illustration 426 g00658310
Top View Of Front Frame
Illustration 427 g00658343
(C) 15 5 mm (0.6 0.2 inch). (D) 350 5 mm (13.8 0.2 inch). (E) 3 mm (0.1 inch) fillet weld.
Illustration 428 g00658361
(H) 3 mm (0.1 inch) fillet weld at two places. (J) 340 5 mm (13.4 0.2 inch). (K) 50 5 mm (2.0 0.2 inch). (L) 55 2 mm (2.2 0.1 inch). (M) 505 5 mm (19.9 0.2 inch).Note: Clean the weld area of paint and grease before welding.
Weld three 9R-2613 Boss (1), as shown. Refer to Illustrations 427 and 428.Note: Clean the weld area and paint the weld area prior to assembly.
Illustration 429 g00658573
View Of Right Rear Of Front Frame
Illustration 430 g00658588
Top View Of Front Frame (X). 9X-6772 Cable Strap (2). 8T-4121 Washer (3). 8T-4136 Bolt (4). 4P-7581 Clip (5).
Illustration 431 g00658691
(X). 9X-6772 Cable Strap (2). 8T-4121 Hard Washer (3). 8T-4136 Bolt (4). 4P-7581 Clip (5) .
Illustration 432 g00658753
Rear View Of Front Frame
Illustration 433 g00658754
Detail (P) .
Illustration 434 g00658757
Left Rear View Of Hydraulic Oil Tank (X). 9X-6772 Cable Strap (2). 8T-4121 Hard Washer (3). 8T-4136 Bolt (4). 4P-7581 Clip (5) .
Install 245-9874 Harness (7), as shown. Refer to Illustrations 429 through 434. Note: If jumper wire (19) is required to connect the new harness to the old components, the wire can be ordered through your dealer.
Install 175-6976 Harness (10) to the hydraulic oil tank.
Install three 9X-7781 Bypass Switch (9) to the filters.
Install three 170-3498 Harness (16) .
Install 123-2993 Liquid Level Switch (12) with 2M-9780 O-Ring Seal (11) to the hydraulic tank.
Install 100-3055 Temperature Sensor (15) with 3J-1907 O-Ring Seal (13) to the lube filter for the front pump drive.
Install the following parts, as required: three 4P-7429 Clip , 6D-4246 Clip , 35 4P-7581 Clip , seven 4P-8134 Clip , eight 8T-4121 Hard Washer , five 8T-4133 Nut , five 8T-4136 Bolt , 54 9X-6772 Cable Strap , 9U-2277 Clip Assembly and all hardware that was previously removed.
Verify that the 224-6645 Power Train Software has been installed. The 224-6645 Power Train Software should be flashed to the power train ECM if the 224-6645 Power Train Software has not been installed.