HOSE AS 3658458 - Caterpillar

Preparatory Work Before Taking the Machine out of Service
The measures indicated below refer to putting the machine out of operation for 30 days or longer.
Check whether oil or other fluids leak from the machine.
Clean the engine with a high-pressure cleaner in a suitable place.
Carefully clean and dry the entire machine.
Spray an anticorrosion agent onto bare metal parts of the machine (for example, piston rods of hydraulic cylinders).
Apply grease to all lubrication points.
Change engine oil.
Check the hydraulic and engine oil level and the coolant level, fill up if necessary.
Store the machine indoors if possible.
If the machine is stored outdoors, place the machine on a wooden base and cover the machine with a watertight tarp to protect the machine against humidity.
Fill up the fuel tank to the maximum level.
Lower the boom and the stabilizer blade to the ground.
Shut off the engine and cycle the joystick controls. Move the hydraulic lockout control to the RAISED position.
Switch off the fuel prefilter on the upper carriage and the fuel filter on the engine (turn to OFF).
Remove the battery and store the battery in a safe place. Charge the battery and carry out battery maintenance at regular intervals.
After the exhaust system has cooled down, seal the exhaust pipe and the air intake opening of the air filter system. Putting the Machine into Operation Again
The following measures must be taken if the machine is out of service for more than 30 days.
Remove anticorrosion agent from the piston rods.
Charge (if required), install and connect the battery.
Remove the seals from the exhaust pipe and the air filter intake.
Check the condition of the air filter elements and replace the elements if necessary.
Check the dust valve.
Switch on the fuel prefilter on the upper carriage and the fuel filter on the engine (turn to ON).
Turn the ignition to position "I" for 2 minutes (to supply the engine with fuel).
Check whether oil or other fluids leak from the machine.
Apply grease to all lubrication points.
Check the hydraulic and engine oil level and the coolant level, fill up if necessary.
If the machine was out of service for over 6 months, change the hydraulic oil, the engine oil, and also replace the hydraulic oil filter.
Remove the fuse for the cutoff solenoid.
Crank the engine for 15 seconds. Wait 15 seconds. Crank the engine again for 15 seconds.
Install the fuse.
Start the engine.
Let the engine run at idling speed at least 15 minutes without load.Operate the machine and make sure that every function and all the safety and warning devices are working properly, before putting the machine back into service.