HOSE AS 3662632 - Caterpillar

Adjust all mirrors as specified in the Operation and Maintenance Manual. Failure to heed this warning can lead to personal injury or death.
Slips and falls can result in personal injury. Use the machine's access systems when adjusting the mirrors. If the mirrors cannot be reached using the machine access systems follow the instructions found within the Operation and Maintenance Manual, "Mirror" in order to access the mirrors.
Mirrors provide extra visibility around your machine. Make sure that the mirrors are in proper working condition and that the mirrors are clean. Adjust all mirrors at the beginning of each work period and adjust the mirrors when you change operators.Modified machines or machines that have extra attachments may influence visibility in the mirrors. For more information refer to this Operation and Maintenance Manual, "Visibility Information" and , "Restricted Visibility".Note: Your machine may not be equipped with all the mirrors that are described in this topic.
Illustration 1 g06084288
(1) Right side rear view convex mirror
(2) Right front corner convex mirror
(3) Left side rear view convex mirror
(4) Left front corner convex mirrorMirror Adjustment
Park the machine on a level surface.
Stop the engine.Note: Hand tools will be needed to adjust the mirrors. Refer to Specifications, SENR3130, "Torque Specifications" for the recommended torque.Right Side Rear View Mirror (1)
Illustration 2 g01604157If equipped, adjust the lower right side rear view mirror to provide visibility to the following areas from the operator seat:
the right side of the dump body and the rear tire as shown in illustration 2
the point of contact between the right rear tire and the ground
an obstacle on the ground 1 m (3.3 ft) from the right side of the dump bodyThere are two bolts on the back of the mirror and two bolts on the mirror bracket for the adjustment of the lower right side rear view mirror.Right Front Corner Mirror (2)
Illustration 3 g01625877If equipped, adjust the right front corner mirror to provide visibility to the following areas from the operator seat:
the full width of the front bumper as shown in illustration 3
an obstacle on the ground 1 m (3.3 ft) from the right front corner of the machine
an obstacle on the ground 1 m (3.3 ft) from the front of the machineThere are two screws on the back of the mirror for the adjustment of the right front corner mirror.Left Side Rear View Mirror (3)
Illustration 4 g01687240If equipped, adjust the left side rear view mirror to provide visibility to the following areas from the operator seat:
the left side of the dump body and the rear tire as shown in illustration 4
the upper left edge of the dump body that will allow the truck to be positioned for loading by viewing the loader bucket pivot pin
the point of contact between the left rear tire and the ground
an obstacle on the ground 1 m (3.3 ft) from the left side of the dump bodyThere are three bolts on the back of the mirror and four bolts on the mirror bracket for the adjustment of the left side rear view mirror.Left Front