HOSE & TUBE AS 3728230 - Caterpillar

Illustration 1 g01374644
Use the Arrow Key in order to scroll to a design.
Press the "OK" key in order to load the design and return to the guidance views.
Press the Next key in order to change the views.For more information on using the views, refer to the following information:
Operation and Maintenance Manual, "Plan View"
Operation and Maintenance Manual, "Profile View"
Operation and Maintenance Manual, "Cross Section View"
Operation and Maintenance Manual, "Text View"
Ensure that the "GPS Accuracy Mode" is suitable for the type of work that will be done. For more information, Refer to Operation and Maintenance Manual, "GPS Accuracy Mode".
Check that the vertical offset value is correct. The "elevation offset" method should be selected. For more information, Refer to Operation and Maintenance Manual, "Vertical Guidance".
Check that the horizontal offset value is correct.For more information, Refer to Operation and Maintenance Manual, "Selecting an Alignment for Horizontal Guidance".
Check that the Status Bar shows the correct horizontal and vertical offset values. For more information, Refer to Operation and Maintenance Manual, "Setting a Horizontal Offset".
Check that the "Bucket: Left" Soft Key or the "Bucket: Right" Soft Key shows that the required bucket tip is selected.Note: Depending on the operator configuration settings of the system, some of the options, Soft Keys, or views that are discussed in this manual may not be available. Other options, Soft Keys or views may be available.