HOSE AS 3749944 - Caterpillar

Illustration 5 g00604558
Install pin (15) and cover (12) with four new bolts (11). Tighten the four bolts lightly.
Use Tool (B) to measure the gap between cover (12) and the housing of the front axle.
Remove cover (12) and pin (15).
Add shim pack (13) accordingly to provide an end play of 0.03 mm (0.0012 inch) to 0.08 mm (0.0031 inch) in the pin.
Install the following components with four bolts (11): cover (12), shim pack (13), seal (14), and pin (15).
Tighten four new bolts (11) to a torque of 80 15 N m (60 10 lb ft) and then turn each bolt by an additional 120 5 degrees.
Illustration 6 g00551910
Connect tube assembly (9) and (10) at the connection.
Repeat Step 11 for the remaining tube assembly.
Illustration 7 g00551900
Connect three hose assemblies (4).
Illustration 8 g00551895
Always use new bolts for the front drive shaft. Failure to use new bolts may result in damage to the drive shaft or damage to the machine.
Position the front drive shaft for installation. Install four bolts (3) that connect the front drive shaft to the yoke. Tighten the four bolts to a torque of 530 70 N m (390 50 lb ft).
Illustration 9 g00551907
Install bolt (8) and the washer.
Illustration 10 g00546441
Illustration 11 g00546440
Position a lift truck under tire and rim (1). Use the lever puller from Tooling (A) to fasten tire and rim (1) to the lift truck. Position the tire and rim for installation.
Install 61 nuts (2) and the washers.
Illustration 12 g00604560
Use Tooling (C) to tighten the 61 nuts in an alternating sequence to 1300 200 N m (960 140 lb ft) and then turn each bolt by an additional 90 5 degrees in an alternating sequence.
Illustration 13 g00540960
The tire and rim assembly can also be positioned for installation by using a tire handler, as shown.
Illustration 14 g00602705
Remove Tooling (D) and the suitable stands.
Illustration 15 g00551903
Install plug (6) into fixed axle (5). Fill the fixed axle with the appropriate lubricant. Refer to Operation and Maintenance Manual, "Differential and Final Drive Oil Level - Check" for the correct procedure to fill the fixed axle. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the appropriate oil.
Illustration 16 g00602280
Install plug (7) into the final drive. Fill the front axle housing and the two final drives with the appropriate lubricant. Refer to Operation and Maintenance Manual, "Differential and Final Drive Oil Level - Check" for the correct procedure to fill the fixed axle. Refer to Operation and Maintenance Manual, "Lubricant Viscosities" for the appropriate oil.
Illustration 17 g00602704
Remove Tooling (E).End By:
Separate the frame lock link. Refer to Disassembly and Assembly, "Steering Frame Lock - Separate and Connect".
Remove the wheel chocks. Refer to Disassembly and Assembly, "Wheel Chock (Front and Rear) - Remove and Install".