HOSE AS 3870164 - Caterpillar

GPS
The RadioLink utility allows you to change the network number or the frequency channel on a TC900C or a TC450C radios. The RadioLink utility runs on the AccuGrade Display. You can only configure radios that have firmware version 1.4.Starting RadioLink and Connecting to the Radio
For machines running Version 5.5 firmware, proceed to Step 5.
For AccuGrade systems running 6.1 firmware, select the "Installation" soft key from the "Setup" menu.Note: By default, the "Installation" soft key is not available to the operator. This option can be turned on by your site manager or Caterpillar.
Illustration 1 g01244461
Press the up arrow or the down arrow until "Launch RadioLink" is highlighted.
Illustration 2 g01020701
Press the "OK" key. The utility automatically attempts to connect to the radio.A dialog similar to the dialog in Illustration 2 appears.Proceed to Step 12.
Power down the system.
Press the 3rd and 4th softkeys while powering up the display. Hold the keys down until the splash screen appears.
Press the "NEXT" key twice.
Select the "Windows" folder by using the arrow keys.
Press "OK".
Press the "NEXT" key twice.
Select the "RadioLink.exe" file by using the arrow keys and press "OK".
For TC900C Radios, use the arrow keys to select the same network (1-40) as the base station.
For TC450C Radios, use the arrow keys to select the same freguency as the base station.TC900C Data Radios
RadioLink only works with radios that have firmware versions 1.40 or later.
Illustration 3 g01248358
If RadioLink detects a TC900C radio, the dialog in Illustration 3 appears.The network number that is shown defaults to "Unknown".
Use the down arrow key and the up arrow key in order to select the required network channel (Network 1–40).
Press the "OK" key in order to save the radio network changes and power down the Display, or press the "ESC" key in order to cancel the changes.Note: The radio must have the same network number as the base station radio that you want to receive GPS corrections.Failed Connection
Do the following if the connection fails.
Check that the radio is connected to the system the machine harness.
Illustration 4 g01248359
Press the soft key "Connect to radio" in order to reconnect to the radio when the dialog in Illustration 4 appears.TC450C Data Radio
Illustration 5 g01248361
If RadioLink detects a TC450C radio, the screen shown in Illustration 5 appears.Note: The TC450C has a selection of up to twenty preset frequency channels.Note: The current radio frequency channel is displayed on start up.
Use the down arrow key and the up arrow key in order to select the channel that is desired.
Press the "OK" key in order to save the radio frequency channel and power down the Display, or press the "ESC" key in order to cancel the changes.Note: The radio must have the same frequency channel as the base station radio that you want to receive GPS corrections. In most areas, licensing is required for 450 Mhz frequencies. Be sure the frequency that is selected is licensed with the customer. Configuring The Radio Port Of The Display For A Third Party Radio
The AccuGrade System can be configured for use with a third party radio. For