AVSPARE.COM
parts catalog

HOSE AS 3904386 - Caterpillar



3904386 HOSE AS Caterpillar parts HOSE
Rating:
46
Alternative (cross code) number:
CA3904386
390-4386
3904386
Caterpillar 3904386 HOSE AS

Buy HOSE AS 3904386 Caterpillar genuine, new aftermarket tractor parts with delivery

  For full view, you need register

Information:

The custom event is viewable but, the default text is shown on the EMCP 4 display instead of the custom string that the user programmed.Test Step 1. VERIFY THAT THE CONTROL PANEL DISPLAY IS SET TO THE PRIMARY LANGUAGEThe control panel display supports a user language (which may be English, or perhaps a different language) as well Technician English. If your primary language is English, you may not notice that the display is set to Technician English. Check the language setting.Note: The user language of English and Technician English look nearly identical.You can change the language setting from the main menu by selecting "Preferences > Language".Expected Result:Technician English should not be selected.Results:
OK - The language is not set to Technician English. Proceed to Test Step 2.
NOT OK - Scroll down to the primary language and press the "OK" key on the EMCP 4 display to change the language. Go back into the event log and verify that the custom string is being displayed for the custom event when the corresponding input is activated.STOPTest Step 2. VERIFY A CUSTOM STRINGVerify that a custom string was created and uploaded using "Modifiable Text Strings" tool within Cat ET.Enter the "Modifiable Text Strings" tool and click "Load from ECM". Verify that the custom event you are trying to display with a custom text string has the custom string displayed here.Note: The "Modifiable Text Strings" tool is only available if the EMCP was selected when Cat ET was started.Expected Result:There is a text string shown to the right of the custom event you are trying to configure.Results:
OK - There is a custom string defined for the custom event you are trying to configure. Proceed to Test Step 3
NOT OK - Enter a custom string.Repair: Double-click to the right of either "Line 1" or "Line 2" of the custom event, and type in your custom string. When you are finished, click "Save To ECM" to upload your changes to the EMCP 4.STOPTest Step 3. CHECK THAT THE EVENT RESPONSE IS ENABLEDEach event, such as "Custom Event #1 Condition Exists", has an associated event response configuration. The event response configuration must be enabled for the event to show up in the event log.Expected Result:The "Custom Event #X Condition Exists Event Response Configuration" for the particular custom event you are trying to trigger, should be set to "Warning", "Soft Shutdown", "Hard Shutdown" or "Active Only" (other settings are optional).Results:
OK - The setpoint is already configured.Repair: Call your customer support representative for further assistance.STOP
NOT OK - Change the setpoint. You need either security level 2 access, or access to Cat ET, to change this setpoint. Make sure the ECS is set to stop before attempting to change this setpoint. STOP


Parts hose Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.