AVSPARE.COM
parts catalog

HOSE AS 3966844 - Caterpillar



3966844 HOSE AS Caterpillar parts 730C HOSE
Rating:
70
Alternative (cross code) number:
CA3966844
396-6844
3966844
Caterpillar 3966844 HOSE AS

Buy HOSE AS 3966844 Caterpillar genuine, new aftermarket tractor parts with delivery
ARTICULATED TRUCK, EJECTOR TRUCK,

Compatible equipment models: 3966844:

ARTICULATED TRUCK  730C  
EJECTOR TRUCK  Caterpillar
  For full view, you need register

Information:


Illustration 1 g01625276
Schematic of the "Generic Hyd Function" sensor
The CID 2206 diagnostic code is associated with the generic hydraulic function sensor. The FMI 08 diagnostic code means that the Implement ECM reads the duty cycle of the sensor as being out of range.The position sensor is a PWM sensor that operates at a frequency of approximately 500 Hz. The sensor has an operating duty cycle of 10% to 90%.The possible causes of this condition are listed below:
The signal circuit is shorted to the +battery or shorted to ground intermittently.
The signal circuit is open intermittently or the sensor is disconnected.
The sensor may have failed.
The ECM may have failed. This condition is unlikely.System Response:
A level 2 warning will be generated.
The "Auto Stow" function is disabled.
The "Ripper In/Out" functions are disabled.
The "Limp Home" function is available.Note: This diagnostic code is usually an intermittent condition. The diagnostic code may be active or the diagnostic code may not be active.Note: This procedure can cause new diagnostic codes to be recorded. Ignore these created diagnostic codes. When the procedure is completed, clear the created diagnostic codes.Test Step 1. CHECK FOR POWER AT THE SENSOR
Do not disconnect the harness connector from the sensor.
At the back of the harness connector for the sensor, insert a 7X-1710 Multimeter Probe along contact 1 (wire 709-OR(Orange)) for the voltage supply.
Turn the key start switch and the disconnect switch to the ON position.
Measure the voltage from contact 1 (wire 709-OR(Orange)) to contact 2 (wire 210-BK(Black)). Expected Result:The voltage is 10 VDC.Results:
OK - The voltage is 10 VDC. Proceed to Test Step 3.
NOT OK - The voltage is not 10 VDC. The circuit is open.Repair: Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE SIGNAL CIRCUIT OF THE SENSOR
Turn the key start switch and the disconnect switch to the OFF position.
At the back of the harness connector for the sensor, remove the 7X-1710 Multimeter Probe from contact 1. Insert the probe along the signal wire (contact 3).
At the back of the harness connector for the sensor, insert the 7X-1710 Multimeter Probe along the ground wire (contact 2).
Turn the disconnect switch and the key start switch to the


Parts hose Caterpillar catalog:

1316645 HOSE
120G, 12G, 12H, 12H ES, 12H NA, 130G, 140G, 140H, 140H ES, 140H NA, 143H, 14G, 14H, 14H NA, 14M, 160G, 160H, 160H ES, 160H NA, 163H, 163H NA, 1673C, 16H, 16M, 215B, 235B, 235D, 3176C, 3196, 330, 330 L...
8C3681 HOSE
120K, 120K 2, 120M, 120M 2, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 140G, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 16H, 16H NA, 225D, 231D, 236D, 242D, 2...
1204553 HOSE AS
416C, 420D, 426C, 428C, 428D, 428E, 432D, 432E, 436C, 438C, 438D, 442D, 442E, 730, 730C
1945171 HOSE
120M, 120M 2, 12M, 12M 2, 12M 3, 12M 3 AWD, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3,...
1226869 HOSE-HYDRAULIC
216, 216B, 216B3, 226B, 226B3, 228, 232B, 236, 236B, 236B3, 236D, 242B, 242B3, 242D, 246C, 247, 247B, 247B3, 248, 252B, 252B3, 256C, 257B, 257B3, 257D, 259B3, 259D, 262C, 262C2, 267, 267B, 268B, 272C,...
9X2133 HOSE
120K, 120K 2, 120M, 120M 2, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 303, 303.5C, 303.5D, 303.5E, 303C CR, 3...
6V8523 HOSE
1090, 1190, 1190T, 120K, 120K 2, 120M, 120M 2, 1290T, 12K, 12M, 12M 2, 12M 3, 12M 3 AWD, 1390, 140K, 140K 2, 140M, 140M 2, 140M 3, 140M 3 AWD, 14M, 160K, 160M, 160M 2, 160M 3, 160M 3 AWD, 16M, 24M, 30...
1661350 HOSE AS
1090, 1190, 2290, 2390, 511, 521, 657E, 730C, TK721
1799407 HOSE AS
24M, 725, 730, 730C
2087973 HOSE AS
725C, 730C, 735, 735B, 740, 740B
2765394 HOSE AS
324D FM, 324D FM LL, 325D FM, 325D FM LL, 325D MH, 730C, M325D L MH, M325D MH
Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.