HOSE 3H1224 - Caterpillar

Installation Procedure
Table 1
Required Tools
Tool Part Number Part Description Qty
A 1P-0520 Driver Gp 1
E 4C-6141 Bearing Installer 1
F 4C-9634 Puller Stud 1
6V-3175 Double Acting Cylinder 1
1P-1837 Bearing Puller Adapter 1
9U-6832 Nut 1
G 8T-5096 Dial indicator 1
When you are using hydraulic cylinders and puller studs, always ensure that the rated capacity of the puller stud meets or exceeds the rated capacity of the hydraulic cylinder. If the puller stud does not meet or exceed the rated capacity of the hydraulic cylinder, a sudden failure of the puller stud could occur. The sudden failure of the puller stud could result in personal injury or death.
Illustration 1 g02911497
Install retaining ring (16), bearings (13), spacer (14), and shaft (17) into gear (15). Install retaining ring (12).
Illustration 2 g02911384
Illustration 3 g02911240
Install gear assembly (11). Install bolt (10).
Illustration 4 g02924277
Use Tooling (F) in order to Install bearing cup (9).
Illustration 5 g02923357
Use Tooling (E) and a suitable press in order to install bearing (8). Repeat for the opposite side.
Illustration 6 g02924022
Use Tooling (A) and a suitable press in order to Install bearing cup (7) into flange (2).
Illustration 7 g02910317
Illustration 8 g02925596
Install gear assembly (5), shims (6), and adapter (2).
Use Tooling (G) to measure the end play of gear assembly (5). Use shims (6) as needed to obtain an end play measurement of 0.10 mm (0.004 inch) to 0.20 mm (0.008 inch).
Illustration 9 g02894349
Install bolts (3) and plate (4).
Install bolts (1) and adapter (2). End By:
Install the gear pump.
Connect the transmission and torque converter.