HOSE AS 3N7223 - Caterpillar

Illustration 9 g00773486
Fuel/water separatorsTwo fuel/water separators are mounted on the fuel tank. The fuel/water separators are connected in parallel. The fuel/water separators provide primary filtration for the fuel for the engine.Wiring for Power Module Enclosure
Batteries
Illustration 10 g00773491
Batteries
Illustration 11 g00773498
Battery disconnect switchThe batteries for the power module are mounted in racks on the floor along one side of the generator set against the wall. The batteries provide power for the engine and for 24 volt interior lighting. The batteries are connected to a battery charger and to the alternator for charging. A battery disconnect switch is mounted to the generator. The battery disconnect switch is used to prevent the engine from being started while the power module is not being used. The battery disconnect switch is used to prevent any battery drain while the power module is not being used.Auxiliary AC Power Distribution
Circuit breakers are available for 120/240 volt auxiliary power distribution.Interior Lighting
Illustration 12 g00773502
Interior lighting
Illustration 13 g00773508
Switches for interior lightsThere are 24 volt interior lights that are mounted in the engine area and in the operator control area inside the power module. The lights are wired to a timer switch. The timer switch is mounted on the wall, next to the entrance. These lights are powered from the batteries.Incandescent lighting and fluorescent lighting that is 120 volt is available as an option.Outlets
Illustration 14 g00773515
Electrical outlet receptacleElectrical outlet receptacles that are mounted to the wall are available as an option.Switchgear
Illustration 15 g00773522
Floor-standing switchgearA floor-standing switchgear and controls are provided with the power module. This is for the proper controls and protection of the generator set. The following components are included within the switchgear.Electronic Modular Control Panel (EMCP II)
The EMCP II monitoring system components for the engine and for the generator are contained in the switchgear. Paralleling
The controls for manual paralleling include the following components: synchronizing lights, switch and reverse power relay.Semiautomatic paralleling and automatic paralleling are available as an option.Circuit Breaker
The circuit breaker is a manually operated breaker. The circuit breaker is solid-state for overload and fault protection. The circuit breaker includes a DC shunt trip coil that is activated by any monitored fault from the generator set. The circuit breaker is sized for full load capacity of the generator set.Circuit breakers that are electrically operated are available as an option.Load Sharing Module
The switchgear is equipped with a load share module for governing of the engine during parallel operation. The load share module contains the following controls for operation: speed adjust potentiometer, idle/rated switch and isochronous/droop switch.Transformers
Three transformers are included in the switchgear in order to reduce the voltage for auxiliary power for the power module. Two transformers are connected to the generator leads connection of the circuit breaker. One transformer is connected to the load connection of the circuit breaker. The transformers are protected from an overload with fuses.Bus Bars
Illustration 16 g00773433
Bus bar assemblyThe