HOSE AS 4186449 - Caterpillar

Table 1
D9N     (S/N: 6XJ1-UP)    
D9N     (S/N: 1JD1-2711) (1)    
D9N     (S/N: 1JD2712-UP)    
D9N     (S/N: 5FJ1-UP)    
D9R     (S/N: 7TL1-UP)    
D9R     (S/N: 8BL1-UP)    
D9R     (S/N: ABK1-UP)    
D9R     (S/N: JJB1-UP)    
D9R     (S/N: ACL1-UP)    
D9T     (S/N: RJS1-UP)    
( 1 ) When applying this Service Magazine to machines (S/N: 1JD1-2711) you must first apply Service Magazine, SEPD0099, 10 February 1992. Refer to Table 2 for the parts that are necessary to adapt to the new bolts. Refer to Illustration 1 and Illustration 2 for the difference between the new bolts and the old bolts.
Table 2
Necessary Parts    
Item     Qty     Part Number     Description    
1     24     9X-6417     Bolt    
2     24     261-8029     Spacer    
3     2     8E-2901     Thrust Plate    
4     2     9S-4185     Plug    
5     2     3K-0360     O-Ring Seal    
6     2     9M-5894     O-Ring Seal    
7     24     1A-8537     Bolt no longer needed.    
8     2     7T-5430     Cover no longer needed.    
Illustration 1 g01116633
The new bolts and the new spacersNote: New Thrust Plate (3) is thinner than the original Cover (8) and the thrust plate will no longer contact the end plate. A properly installed retaining ring ensures that the new thrust plate (3) is installed properly. Refer to Illustration 1 and Illustration 2 for the difference between the mounting of the new thrust plate and the old cover.The torque for the new bolts is 270 40 N m (200 30 lb ft).Lightly lubricate the bore with lubricant that is being sealed before installation of thrust plate (3) and O-ring seal (6). Install plug (4) and O-ring seal (5) to a torque of 84 4 N m (60 3 lb ft) after the installation of thrust plate (3).
Illustration 2 g01116637
The old bolts