HOSE AS 4236337 - Caterpillar

Illustration 1 g00275660
(1) As needed, use shims to achieve the following backlash between bevel gear (2) and pinion (17). ... 0.16 0.06 mm (.006 .002 inch)Note: Use shims from the 8S-0615 Shim Pack to achieve backlash (1) . (3) As needed, use shims to achieve the following end play for the bearings on bevel gear shaft (15). ... 0.10 0.05 mm (.004 .002 inch)Note: Use shims from the 7T-7174 Shim Pack to achieve end play (3) .Check the backlash between pinion (4) and bevel gear (6) .Measure the backlash while you hold pinion (4). The backlash must be 0.315 0.110 mm (.0124 .0043 inch).If the backlash is too high, subtract shims (3) and add the same amount to shims (9) .If backlash is too low, subtract shims (9) and add the same amount to shims (3) . (5) As needed, use shims to achieve the following rolling torque for pinion (4) after five revolutions. ... 1.7 0.5 N m (15 4 pound inch) (7) As needed, use spacers to achieve gap (A) between plate (11) and disc (10) . (A) Gap ... 2.50 0.13 mm (.100 .005 inch) Thickness of one 2P-5809 Spacer ... 0.9 mm (0.04 inch) Thickness of one 2P-5808 Spacer ... 0.25 mm (0.001 inch) Thickness of one 6P-0383 Spacer ... 0.102 0.038 mm (0.0040 0.0015 inch)Note: The maximum gap between plate (11) and disc (10) is 3.75 mm (.148 inch) before discs (10) are replaced or gap (A) is reset. (8) Torque for locknuts ... 875 50 N m (640 37 lb ft) (12) Torque for bolts ... 110 10 N m (80 7 lb ft) (13) 8E-7825 Spring Quantity ... 17 Length under test force ... 25.94 mm (1.021 inch) Test force ... 315 N (71 lb) Free length after test ... 35.96 mm (1.416 inch) Outside diameter ... 22.86 mm (.900 inch) (14) The inboard brake consists of four discs and three plates. Total thickness (new discs and new plate) ... 37.65 0.76 mm (1.482 .030 inch) Thickness of one new 8E-6205 Disc ... 4.65 0.13 mm (.183 .005 inch) Minimum allowable thickness of disc ... 4.01 mm (.158 inch) Minimum allowable groove depth in disc ... 0.32 mm (.013 inch) Thickness of one new 8E-7821 Plate ... 6.35 0.08 mm (.250 .003 inch) Minimum allowable thickness of plate ... 6.19 mm (.244 inch) (16) Put 5P-3931 Anti-Seize Compound on threads of nut. Tighten the nut in order to achieve the following rolling torque for pinion (17) after five revolutions. ... 1.1 0.5 N m (10 4 pound inch) (18) As needed, use shims from the 7T-7917 Shim Pack to achieve dimension (B). Dimension (B) is between the outside diameter of bevel gear (2) and the shoulder of the bearing. ... 3.93 0.05 mm (.155 .002 inch)