HOSE AS 4257363 - Caterpillar

Illustration 1 g01625290
Schematic of the "Ripper Shank Raise" solenoid
The CID 2211 diagnostic code is associated with the ripper shank raise solenoid. The FMI 03 diagnostic code means that the Implement ECM reads the voltage of the solenoid circuit as being above normal.The possible causes of this diagnostic code are listed below:
The harness is shorted.
The ECM has failed. This condition is unlikely.System Response:The diagnostic code of CID 2211 FMI 03 will be logged in the internal memory of the ECM. A level 2 warning will be generated. The "Implement Lockout" solenoid is deactivated (LOCKED) unless the "Limp Home" mode is selected. All blade and ripper functions are disabled.Note: Ensure that the diagnostic code is active.Test Step 1. CHECK THE SIGNAL CIRCUIT FOR A SHORT.
Turn the key start switch and the disconnect switch to the OFF position.
Disconnect the machine harness from the solenoid.
Disconnect the machine harness connectors J1 and J2 from the ECM.
At machine harness connector J2, measure the resistance from the solenoid signal contact J1-58 (wire J921-PK(Pink)) to all other J1 and J2 connector contacts. Expected Result:Each resistance should be greater than 5000 ohms.Results:
YES - Each resistance is greater than 5000 ohms. The machine harness is correct. Proceed to test step 2.
NO - There is a short in the machine harness. Repair: The short is between the signal contact J1-58 (wire J921-PK(Pink)) and the circuit with the low resistance measurement. Repair the machine harness or replace the machine harness.STOPTest Step 2. CHECK THE STATUS OF THE DIAGNOSTIC CODE
Inspect the contacts and clean the contacts of the harness connectors.
Reconnect all harness connectors.
Turn the disconnect switch and the key start switch to the ON position.
Clear all inactive diagnostic codes.
Operate the machine.
Stop the machine and place the parking brake switch in the ON position.
Check the status of the CID 2211 FMI 03 diagnostic code. Expected Result:The CID 2211 FMI 03 diagnostic code is not active.Results:
OK - The CID 2211 FMI 03 diagnostic code is not active. The diagnostic code does not exist at this time. The initial diagnostic code may have been caused by a poor electrical connection that was corrected when a harness connector was disconnected and reconnected.Repair: Resume normal machine operation.STOP
NOT OK - The CID 2211 FMI 03 diagnostic code is active. The problem has not been corrected.Repair: With Caterpillar Electronic Technician (Cat ET) , if available, perform a "Wiggle Test" on the solenoid circuit in the machine wiring harness. The wiggle test may detect momentary or intermittent shorts or opens in the machine wiring harness.If all possible causes of the problem have been investigated and no problem can be found, you may need to replace the Implement ECM.Prior to replacing an ECM, always contact the Technical Communicator at your dealership for possible consultation with Caterpillar. This consultation may greatly reduce repair time and expense. If the ECM must be replaced, refer to Testing and Adjusting, "Electronic Control Module (ECM) - Replace".STOP