HOSE 4360851 - Caterpillar

Personal injury or death can result from the bucket falling.Block the bucket before changing bucket tips.
Bucket Tips
Illustration 1 g00101352
(1) Usable (2) Replace (3) ReplaceCheck the bucket tips for wear. If the bucket tip has a hole, replace the bucket tip.J Series
Remove the pin from the bucket tip. The pin can be removed by one of the following methods.
Use a hammer and a punch from the retainer side of the bucket to drive out the pin.
Use a Pin-Master. Follow Step 1.a through Step 1.c for the procedure.
Illustration 2 g00590670
(4) Back of Pin-Master (5) Extractor
Place the Pin-Master on the bucket tooth.
Align extractor (5) with the pin.
Strike the Pin-Master at the back of the tool (4) and remove the pin.
Illustration 3 g00590819
(6) Retainer (7) Retaining washer (8) Adapter
Clean the adapter and the pin.
Fit retainer (6) into retaining washer (7). Install this assembly into the groove that is in the side of adapter (8) .
Illustration 4 g00101359
Install the new bucket tip onto the adapter.Note: The bucket tip can be rotated by 180 degrees in order to allow greater penetration or less penetration.
Drive the pin through the bucket tip. The pin can be installed by using one of the following methods:
From the other side of the retainer, drive the pin through the bucket tip, the adapter, and the retainer.
Use a Pin-Master. Follow Step 5.a through Step 5.e for the procedure.Note: To correctly install the pin into the retainer, the pin must be driven in from the right side of the tooth. Improper installation of the pin can result in the loss of the bucket tip.
Illustration 5 g00590666
(4) Back of Pin-Master (9) Pin setter (10) Pin holder
Insert the pin through the bucket tooth.
Place the Pin-Master over the bucket tooth and locate the pin in the hole of holder (10) .
Strike the tool with a hammer at the back of the tool (4) in order to start the pin.
Slide pin holder (10) away from the pin and rotate the tool slightly in order to align pin setter (9) with the pin.
Strike the end of the tool until the pin is fully inserted.
After you drive the pin, make sure that the retainer fits snugly into the pin groove.K Series
Removal
Illustration 6 g01124847
(1) Bucket tip (2) Retainer (3) AdapterNote: Retainers are often damaged during the removal process. Caterpillar recommends the installation of a new retainer when bucket tips are rotated or replaced.
Illustration 7 g01175361
Use a pry bar in order to disengage retainer (2) .
Use the pry bar in order to remove retainer (2) from bucket tip (1) .
Remove bucket tip (1) from adapter (3) with a slight counterclockwise rotation.
Clean adapter (3) .Installation
Clean the adapter and the area around the latch, if necessary.
Install the new bucket tip onto the adapter with a slight clockwise rotation.
Illustration 8 g01124736
Install the retainer. Make sure that the retainer's latch catches under the tip pocket.
Make sure that the latch is properly seated by trying to remove the bucket tip.