HOSE AS 4413543 - Caterpillar

Hook Load Line - Install
SMCS Code: 5417-025
Do not use a wire rope cable that is kinked, frayed or has worn spots.
Wear gloves when handling the wire rope cable.
Use 6 X 25 filler wire, right regular lay, independent wire rope core, pre-formed, improved plow steel-type cables. The wire cables should have a minimal breaking strength of 26672 kg (58800 lb).
1. Unroll the new hook winch cable from the spool. Weld the ends of the hook winch cable in order to prevent fraying.
Unroll all of the hook winch cable from the spool. Lay the cable on a flat surface. Never lift the cable off the spool in coils.
2. Install the ferrule for the hook winch cable to the load drum.3. Wind one half of the hook winch cable on the drum. Wind the cable evenly across the drum. 4. Install the hook winch cable from the winch drum to the upper sheave and lower sheave assemblies. Position the hook winch cable over upper sheave (1), under lower sheave (4), over upper sheave (2), under lower sheave (5), over upper sheave (3) and under lower sheave (6). The hook winch cable should go over upper sheave (1) which is toward the front of the machine. Anchor the hook winch cable toward the rear of the machine.5. Insert the hook winch cable into the pocket and around wedge (7). Tap wedge (7) and the cable into the pocket with a mallet.6. Insert the end to the hook winch cable into clamp (8). Tighten the setscrew in the clamp to a torque of 45 7 N m (33 5 lb ft).7. Pull the hook winch cable until the line is tight. Lift the lower block above the ground.8. Raise the boom.