AVSPARE.COM
parts catalog

HOSE AS 4416306 - Caterpillar



4416306 HOSE AS Caterpillar parts HOSE
Rating:
66
Alternative (cross code) number:
CA4416306
441-6306
4416306
Caterpillar 4416306 HOSE AS

Buy HOSE AS 4416306 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 7
 
  For full view, you need register

Information:


Illustration 1 g01267511
Implement ECM 10 VDC Power Supply connections
This diagnostic code is associated with the Implement ECM 10 volt sensor power supply. The 10 volt sensor power supply provides power for the right hand joystick and the auxiliary attachment control components.The CID 1482 FMI 04 diagnostic code is activated when the Implement ECM detects that the voltage of the 10 volt power supply circuit is lower than normal.The following conditions could cause this diagnostic code:
A component that is powered by the power supply has failed.
The power supply circuit is shorted to a ground source.
The ECM has failed. This is unlikely.Note: Before performing this procedure, inspect the harness connectors that are involved in the circuit. Poor connections can often be the cause of a problem in an electrical circuit. Verify that all connections in the circuit are clean, secure and in good condition. If a problem with a connection is found, correct the problem and verify that this diagnostic code is active before performing this procedure. Note: The following test procedure may create other diagnostic codes. Clear the diagnostic codes when the problem has been corrected.Test Step 1. CHECK THE COMPONENTS
Turn the key switch and the disconnect switch to the ON position.
One at a time, disconnect a component that uses the 10 VDC power supply from the machine harness. As each component is disconnected, check the status of the CID 1482 FMI 04 diagnostic code.
Continue disconnecting the components from the machine harness one at a time until the status of the CID 1482 FMI 04 diagnostic code changes or until all of the components that are connected to the 10 volt power supply are disconnected. Expected Result:When one of the components is disconnected from the machine harness, the CID 1482 FMI 04 diagnostic code is no longer active.Results:
OK - The CID 1482 FMI 04 diagnostic code is not active when one of the components is disconnected. The power supply circuit is correct. The component that was disconnected when the status of the CID 1482 FMI 04 diagnostic code changed has failed. Repeat this test step in order to verify which component is causing the problem.Repair: Once the problem component is determined, replace the component. After the component is replaced, verify that the problem has been corrected before operating the machine.STOP
NOT OK - The CID 1482 FMI 04 diagnostic code is still active. Disconnecting all of the components that are using the 10 VDC power supply did not change the status of the diagnostic code. Proceed to Test Step 2.Test Step 2. CHECK THE POWER SUPPLY AT THE ECMAll components that are connected to the 10 VDC power supply remain disconnected from the machine harness.
Turn the disconnect switch and the key switch to the OFF position.
At the Implement ECM connector J1, use a 151-6320 Removal Tool or a similar tool to remove the power supply wire and socket at contact J1-69 (wire 709-OR(Orange)) from the connector. The machine harness connector J1 remains connected to the ECM.
At the Implement ECM connector

Caterpillar parts catalog:

Caterpillar parts catalog
323F L Excavators KBY00001-UP (MACHINE) POWERED BY C7.1 Engine
320F L Excavator NHD00001-UP (MACHINE) POWERED BY C4.4 Engine
320E L OEM FH800001-UP (MACHINE) POWERED BY C6.6 Engine
320E L Excavators TNJ00001-UP (MACHINE) POWERED BY C6.6 Engine
320E, 320E L & 320E LN Excavators DFG00001-UP (MACHINE) POWERED BY C6.6 Engine
323E L, 323E LN & 323E SA Excavators RAP00001-UP (MACHINE) POWERED BY C6.6 Engine
320E & 320E L Excavators AWS00001-UP (MACHINE) POWERED BY C6.6 Engine
323F L Excavators XCF00001-UP (MACHINE) POWERED BY C7.1 Engine
320F L Excavator YBM00001-UP (MACHINE) POWERED BY C4.4 Engine


Parts hose Caterpillar catalog:

Back to top
The names Cat, Caterpillar, John Deere, Komatsu, Volvo, Hitachi, Doosan, JCB, Hyundai or any other original equipment manufacturers are registered trademarks of the respective original equipment manufacturers. All names, descriptions, numbers and symbols are used for reference purposes only.
AVSpare.com is in no way associated with any of the manufacturers we have listed. All manufacturer's names and descriptions are for reference only. Cat® and Caterpillar® are registered trademarks of Caterpillar, Inc.