HOSE 4418078 - Caterpillar

Switch Electrical Specifications
Voltage that is applied to the switches by the ECM will not exceed 13 VDC under normal conditions. The plating on the contacts should not corrode. The plating on the contacts should not oxidize. Gold plated contacts are recommended. The current draw through the switches may not exceed 5.0 mA.The contact chatter is the momentary opening and closing of the contact points. The contact chatter should not exceed 100 milliseconds in duration. The switches should not open and the switches should not close due to vibration or shock that is normally found in the marine environment.The ECM and the internal pull up resistors of the display module force the respective input to an internal pull up voltage when a switch contact is opened or the harness has an open circuit. Closure of OEM installed switches must complete the circuit to the - battery bus bar.Voltage Thresholds that are Measured at the ECM
Voltage in Low
When any of the switch contacts are closed, the voltage drop through the switch circuit must be less than 0.9 VDC. This measurement should be taken at the respective control input and the negative battery input to the ECM. This measurement includes the following values:
Ground potential differences
Voltage drop across the switch
Voltage drop across the wiring harnessVoltage in High
When any of the switch contacts are open, the resistance between the respective control input and the negative battery input to the ECM should not be less than 5,000 Ohms. Potential paths for leakage may exist within the following components:
Connectors
Harnesses
SwitchesNote: OEM installed switches must be connected to negative battery.Switches that are Installed by the Customer
Table 1
Switch     Required Actuator     Type    
3E-8766     155-2706     SPST (1)    
3E-8768     155-2706     SPST Momentary    
3E-8772     155-2705     DPDT (2) Center Off    
( 1 ) Single Pole Single Throw
( 2 ) Double Pole Double Throw
Illustration 1 g00782333
3E-8766 Switch and 3E-8768 Switch (R) ON (top or left) (S) NONE (center) (T) OFF (bottom or right) (1) Actuator orientation tabs
Illustration 2 g00782349
Schematic for 3E-8766 Switch and 3E-8768 Switch When the contacts "2" and "3" of the switch are closed, the backlight connected to switch terminals "A" and "B" turns on.