HOSE AS 4435949 - Caterpillar

Illustration 18 g02962857
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install relief valve assembly (24) into interface module (22). Tighten relief valve assembly (24) to a torque of 11.0 1.0 N m (97.36 8.85 lb in).
Install plug (25). Tighten plug (25) to a torque of 29.5 2.5 N m (21.76 1.84 lb ft).
Illustration 19 g02962829
Install interface module (22). Pre-tighten the nuts to a torque of 9 1 N m (79.7 8.9 lb in). Tighten the nuts to a final torque of 40 2 N m (29.5 1.5 lb ft).
Install studs (23). Tighten studs (23) to a torque of 15 2 N m (132.8 17.7 lb in).
Illustration 20 g02962756
Install O-ring seals (21), O-ring seals (20), O-ring seals (19), and O-ring seals (18) onto steer control valve (3).
Illustration 21 g02962717
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install relief valve and the O-ring seal into steer control valve (3).
Illustration 22 g02965241
Install O-ring seals (16), O-ring seals (15), and O-ring seals (14) onto solenoids (13).
Illustration 23 g02965225
Install solenoids (13) and bolts (12) onto the solenoid blocks.
Tighten bolts (12) to a torque of 4.0 0.5 N m (35.40 4.43 lb in).
Illustration 24 g02962657
Install O-ring seals (11) onto the solenoid block.
Illustration 25 g02959916
Install solenoid block (10) onto saw control valve (3). Tighten the bolts to a torque of 8.5 1.5 N m (75.23 13.28 lb in).
Illustration 26 g02959876
Personal injury can result from being struck by parts propelled by a released spring force.Make sure to wear all necessary protective equipment.Follow the recommended procedure and use all recommended tooling to release the spring force.
Install spool assembly (9), O-ring seal (8), O-ring seals (7) and cover (6). Tighten the bolts on cover (6) to a torque of 8.5 1.5 N m (75.23 13.28 lb in)
Illustration 27 g02962556
Install O-ring seals (5) and O-ring seals (4) onto end cover (2).
Illustration 28 g02962497
Install steer control valve (3), end cover (2), nuts (1), and the washers. Tighten the nuts to a torque of 28.0 2.0 N m (20.65 1.48 lb ft). End By:
Install the bank valve.