HOSE-RADIATOR 4535966 - Caterpillar

4535966 HOSE-RADIATOR Caterpillar parts

Price: query
Add in request price Go to cart

Rating:

Alternative (cross code) number:
CA4535966
453-5966
4535966

Weight: 2 pounds 0 kg.

Buy HOSE-RADIATOR 4535966 Caterpillar genuine, new aftermarket tractor parts with delivery

Number on catalog scheme: 4

Caterpillar 4535966 Parts scheme HOSE-RADIATOR

For full view, you need register

Information:

Start By:
Release the system pressure.
Illustration 1 g02138430
Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 2 g02216734
Remove covers (1) and (2).
Illustration 3 g02216775
Disconnect hose assemblies (4) from pilot valve (3).
Illustration 4 g02216774
Disconnect harness assemblies (5).
Remove bolts (6) and pilot valve (3).
Illustration 5 g06101419
Loosen nut (8) and remove control handle assembly (7).Installation Procedure
Install pilot valve (3) in the reverse order of removal.
Tighten nut (8) to a torque of 49 3 N m (36 2 lb ft).Pilot Valve (Joystick) (Right Hand)
Removal Procedure
Table 2
Required Tools
Tool Part Number Part Description Qty
A 311-1362 Vacuum Gauge Gp 1
Personal injury can result from hydraulic oil pressure and hot oil.Hydraulic oil pressure can remain in the hydraulic system after the engine has been stopped. Serious injury can be caused if this pressure is not released before any service is done on the hydraulic system.Make sure all of the work tools have been lowered to the ground, and the oil is cool before removing any components or lines. Remove the oil filler cap only when the engine is stopped, and the filler cap is cool enough to touch with your bare hand.
Start By:
Release the system pressure.
Illustration 6 g02138430
Remove the cap from the hydraulic tank. Install Tooling (A) onto the hydraulic tank. Attach an air supply hose to Tooling (A). Apply 276 to 414 kPa (40 to 60 psi) of air. This procedure will pull vacuum on the hydraulic system.
Illustration 7 g02217301
Remove covers (1) and (2).
Illustration 8 g02217302
Disconnect hose assemblies (4) from pilot valve (3).
Illustration 9 g02217303
Disconnect harness assemblies (5).
Remove bolts (6) and pilot valve (3).
Illustration 10 g06101432
Loosen nut (8) and remove control handle assembly (7).Installation Procedure
Install pilot valve (3) in the reverse order of removal.
Tighten nut (8) to a torque of 49 3 N m (36 2 lb ft).