HOSE BK 4568438 - Caterpillar

Make sure that bearing (29) is in alignment with the bearing race in the transmission case.
30. Put the original amount of shims (43) in the correct position on the transmission case. 31. Install a new seal (44) on cage (34). Put clean SAE 30 oil on the seal.32. Make sure the oil hole in the cage is clean and free of dirt.33. Put cage (34) in the transmission case (45) with oil hole in alignment with the oil passage in the transmission case. 34. Heat bearing cone (47) to a maximum temperature of 275°F (135°C). Install the bearing on the shaft.35. Install spacer (48). Heat bearing cone (49) to a maximum temperature of 275°F (135°C). Install the bearing on the shaft. Use retainer (50) and two 3/8"-24 NF bolts 2 in. long to install the bearing cone on the shaft. Remove the two bolts. Lower the temperature of bearing cup (46) and install the bearing cup in the cage. 36. Install a new seal (51) on the cage. Put clean SAE 30 oil on the seal.37. Clean the oil passage in retainer (50). Install a new seal (53). Put clean SAE 30 oil on the seal.38. Install retainer (50), lock and bolts (52). 39. Put cover (54) in position on the cage so the groove in the cover is in alignment with the groove in the cage. Install bolts (55).
Do not damage seal (53) when the cover is installed.
40. Fasten a hoist to the transmission. Put the transmission in a horizontal position. 41. Heat bearing (57) to a maximum temperature of 275°F (135°C). Install the bearing on the shaft. Install ring (56) that holds the bearing in position. 42. Put shaft (59) half way into the transmission case. Install forward-reverse gear (58). Push the shaft all of the way into the transmission case.
Make sure that bearing (57) is in alignment with the bearing race in the transmission case.
43. Make sure the oil hole in the cage for the upper shaft is clean and free of dirt. 44. Lower the temperature of the bearing cup and install it in cage (60).45. Put cage (60) in position on the transmission case. Make sure the oil hole in the cage is in alignment with the oil hole in the transmission case. Put cover (61) in position over the cage and install bolts (62). Tighten the bolts until the cage is in all of the way. 46. Remove bolts (62) and cover (61) from cage (60).47. Heat bearing cone (65) to a maximum temperature of 275°F (135°C). Install the bearing cone on the shaft. Install spacer (63).48. Heat bearing cone (66) in oil to a maximum temperature of 275°F (135°C). Install the bearing on the shaft.49. Lower the temperature of bearing cup (67). Install the bearing cup in the cage. 50. Install seal (64) in cover (61) with tooling (B). Install the seal with the lip of the seal toward the inside of the cover and until it is .298 in. (7.6