HOSE BK 4568441 - Caterpillar

41. Put plate (49) in position on No. 2 clutch housing. 42. Install clutch disc assemblies (50) and plate (52) on plate (49). Start with a disc assembly. Install ring gear (51).
Make sure the clutch disc assemblies are free from dirt and oil. Do not cause damage to the teeth of the discs.
43. Lower the temperature of the bearing for No. 1 carrier. Install the bearing in the carrier. 44. Install bearings (57) in gears (56) and install tubes (55) in shafts (54). Put shafts in position in No. 1 carrier. Install balls (53) in shafts (54). Put gears (56) and washers (58), one on each side of gears in position in No. 1 carrier. Install the shafts through gears and into No. 1 carrier.
Make sure balls (53) are in shafts when shafts are installed.
45. Put gear (59) in No. 1 carrier. Install plates (62), locks (61) and bolts (60) in No. 1 carrier. 46. Install balls (63) in shafts (64). Install the bearings in gears (66). Put a washer (65) on each side of gears (66). Put the gears in position in No. 1 carrier and install shafts (64) as shown. 47. Install three clutch disc assemblies and two plates (70). Start with a disc assembly. Install ring gear (69).48. Install two 3/8"-16 NC forged eyebolts in No. 1 carrier. Install No. 1 carrier (67). 49. Install new rings in piston (71) and No. 1 clutch housing (72).50. Put a small amount of clean oil on the rings. Install the piston (71) in No. 1 clutch housing (72) as shown.
Do not cause damage to the rings when the piston is installed in the clutch housing.
51. Install the five pins (73) and ten springs (74).52. Use tool (D) to hold the piston in No. 1 clutch housing.53. Install two 1/2"-13 NC forged eyebolts in No. 1 clutch housing. Fasten a hoist to No. 1 clutch housing and install it in the correct position shown. 54. Install the three of the bolts (75) the same distance apart that hold the clutch housings together. Tighten the bolts to a torque of 85 5 lb.ft. (115 7 N m).55. Install the other six bolts. Tighten the bolts to a torque of 85 5 lb.ft. (115 7 N m). 56. Heat the race to a temperature of 275°F (135°C). Install the race (76) on the shaft. Install the ring seal (77) on the race. 57. Install the bearing (78) in the cage. Install ring (79) to hold bearing in position.58. Slide the shaft through the bearing and cage as shown. Use a soft faced hammer to install the cage on the shaft.59. Slide the gears (82) on the shaft. 60. Heat the race (80) to a temperature of 275°F (135°C). Install the race on the shaft. Install ring (81) on the shaft. 61. Install spacer (83) and bearing (84) in the cage. Install the two rings that hold the bearing and spacer in position. 62. Install a new