HOSE BK 4568459 - Caterpillar

2. Disconnect water temperature line (1). Remove clips (2) that hold the line in position on the engine. 3. Disconnect tube assemblies (3) and (4) for the fuel pressure and oil pressure. 4. Disconnect rod (5) for the governor control. On power shift machines, disconnect the rod for the decelerator linkage.5. Disconnect wiring harness (6). 6. Disconnect air conditioner compressor clutch wire (7) in the dash if so equipped.7. Disconnect the torque converter oil temperature sending unit from the torque converter outlet relief valve on power shift machines only. 8. Disconnect two rods (8) at the dash for the steering clutch controls.9. Disconnect two rods (9) at the dash for the brakes. 10. Install two 3/8"-16 NC forged eyebolts in the top of the dash as shown. Fasten a hoist to the dash. 11. If the machine is equipped with a cab, remove tooling (10) that is used to hold the dash in position when the cab is tilted back. The dash can then be removed. If the machine does not have a cab, remove the bolts and bushings that hold the dash in position. Remove dash (11). The weight of the dash is 200 lb. (90 kg).Install Dash
1. Fasten a hoist to dash (1) and put it in position on the machine. 2. If the machine has a cab, install tooling (2) to hold the dash in position when the cab is tilted forward.3. If the machine does not have a cab, install the bolts and bushings that hold the dash in position. 4. Connect two rods (3) for the brakes at the dash.5. Connect the two rods for the steering clutches at the dash.6. Connect the torque converter oil temperature sending unit to the torque converter outlet relief valve on power shift machines only. 7. Connect the air conditioner compressor clutch wire (4) in the dash if so equipped. 8. Connect rod (5) to the lever for the governor control. On power shift machines, connect the rod for the decelerator pedal.9. Connect wire harness (6). 10. Connect tube assemblies (7) and (8) for the fuel pressure and oil pressure. 11. Install water temperature sending unit (10) in the cylinder head. Install all clips (9) that hold the sending unit line in position on the engine.12. Fill the cooling system with coolant to the correct level with coolant. See Lubrication and Maintenance Guide.end by: (for machines without a cab)a) install Roll-Over Protective Structure